Microphones

PRIMO - EM-47A Audio, Microphone.

From live concert sound to recording a movie, pro-audio microphones are critical to the clarity of the sound. Primo's products are use inside many major brands from vocal mics to shotgun camera mics, our quality is perfect for professional and amateurs alike.

Electric Condenser Microphone Cartridge.

Omni-directional.

Highest quality, very high output into 200Meg Ohm to 500Meg Ohm, using FET AMP with source follower.

Has no internal preamps.

Can withstand very high S.P.L. (sound pressure level over 90db?).

Dimensions: 0.828" (21mm) D x 10.5mm high.

Threaded.

Learn More

FV272/1740 - Audio, Microphone Element, Dynamic.

Element Miniature.

Dimensions: Approximately .764"X .50" X .36" (19.5 X 12.7 X 9.0 mm)

Strong on Higher Frequencies.

Researching this element to confirm if it is the Heil HC-5 that is in high in demand by Ham Radio Enthusiasts

Note: Purchased from Astatic following their plant closure.

Made in Taiwan

Learn More

RCA Tac Tec Astatic - M1569029 Microphone.

Replacement Microphone for RCA Tac Tec 2-Way Radio Receivers. (Spec1476A).

Retractable Coiled Cord

7 Position Female Connector.

Spec. 1476A

Rare - New Old Stock - Vintage collectable

Made in Japan

Learn More

Audio, speaker. CB Series miniature speaker, Z=24 ohm. Port on face, can function as a microphone or beeper. Enclosed, stainless steel. Mount: PCB. Dimensions: square 25.15mm long x 25.15mm wide x 9.65mm high. Very Nice. Learn More

Microphone, dynamic. Military. 24VDC 150 Ohm 300-3500Hz, 10 Dynes per square cm. With coiled stretch cord and 5 Pin circular connector. Used with Military radios and pa systems. A microphone which depends for its operation upon the generation of an electromotive force by the motion of a moving coil within a magnetic field. Water resistant. Note: Military NSN 5965-00-179-7762. Learn More

ASTATIC - MC559-2 - Dynamic Audio, Microphones Element.

Ceramic Audio Microphone Element

Ceramic Element

Frequency Response 300 - 5,000 Hz. 

Element 1.03"OD.

Dimensions: 1.166" oval x 0.45" thick, excluding two terminals.

Vintage New Old Stock

Used as replacement for Astatic Model used in 331 Mobile Microphone, Kodak PA3 Microphone, JT30 Ceramic Harp Microphone and others. 

Learn More

ASTATIC - MC559 - Dynamic Microphone, Ceramic Element.

The Astatic Corporation has been a symbol of quality sound reproduction since its founding in 1930. As a pioneer manufacturer, Astatic has contributed extensively to the art of audio reproduction and has maintained a position of leadership in the field of microphones as well as phonograph cartridges and needles.

Factory New Microphone Elements 26.8mm mount Overall 30.2mm (slighly round / ovular) square face.

Brass tab & Solder Terminal.

Frequency response is 300-5,000hz

Super Hot Output and Nice Crunchy Vintage Tone.

Alternate: Replacement for Astatic Model 331.

Vintage - New Old Stock 

Learn More

Microphone, dynamic. Impedance: 50K Ohm. With on-off switch and a 20' cable, plus mike holder. Learn More

Microphone, electrent condenser. Frequency response 50-16000Hz. Output level -64db@1000Hz. 600 Ohm Impedance. Uni-directional Cardioid. Signal to noise ratio 50db @1000Hz. Complete with a 10' cord and a 1/4" jack. Note: Requires a 1.35V battery, not included. Learn More

ASTATIC - T2M-931 - DTMF Series Microphone

Handheld DTMF Microphone

Rugget Housingfor Professional two-way Communications

Dual tone Multi-FrequencyElectronics.

Compatable with with most applications.

Specially designed acoustic resonator tailots frequencyfor maximum voice intelligibility.

Pre-Amplified Electret

Frequency Response: 50 - 50000 Hz

Less than 100-ohms.

Output Level -35dB re 1Volt/microbar

Power Requirements:10 to 14VDC, filtered at up to 40ma

Auto Kkeyup, audible feedback when any key isp[ressed with hook up instructions.

Speaker / Microphone Matches Virtually any Transmitter.

Micro Switch with Positive Snap Action.

Rotable Spring Clip on Back.

Dimensions: Approximately 211/16 " wide x 3 3/8" high x 2" D.

Complete with 6 wire Neoprene coil cord, extends to 7 feet. 

Includes Hook-up Instructions. 

Proudly Made in USA

Learn More

Calrad - 10-113 - Audio Microphone Splitter.

The Calrad 10-113 Microphone Splitter splits input of a single microphone to two different outputs, both input and output signals may be used to provide separate isolated feeds to both a house and monitor system, P.A. recording system or similar application where double outputs are required. No Power required.

Specifications:
Input Impedance: 600 ohm
Dimensions: 4 3/4" X 3 1/8" x 1 5/8"
Output impedance: 600 ohm
Frequency Response: 20-20k

Color: Black

RoHS Compliant

Learn More