Line Filter

ECS INC - ZTA-3.58MG - Filter/Resonator.

Ceramic Resonator 3.58MHz,

Impedance: 30 Ohm. Tolerance: 0.5%.

Supply Voltage: 100V

Dimensions: 10mm wide x 5mm deep x 7.5mm High.

Package: 2 Pin Radial Leads.

Lead Spacing: 5mm.

Note: Extended Temperature Range.

Additional Information: https://ecsxtal.com/store/pdf/ZTAR.pdf

Package of 10.

SCHAFFNER - FS3184-6-16 - Line Filters

110/250VAC 6Amps

Each with wiring harness

Note: Removed from Equipment

Murata Erie - CFW455F Filter, ladder. 455KHz.

Insertion loss 6 dB.

Input/output impedance 2K Ohm.

Damping width: 12 kHz.

Pass bandwidth: 6 kHz.

Spurious Emission Attenuation: 35 dB.

Application: These steep-edge filters are used in high-quality amateur radio and TV receivers.

Package: Miniature 5 pin dip. (Actual 4-Pin one side/ one pin opposite side).

Dimensions: (L x W x H) 11,7 x 7 x 8,5 mm.

Golledge - CFU455D2 Filter, ceramic. 0.455 MHz.

Mount: PCB, 3 pin.

Dimension: 8mm x 7mm x 8mm high.

New.

Note: More info: http://pdf1.alldatasheet.com/datasheet-pdf/view/87505/ETC/CFU455B2.html

Lot of 10 - LIVINGSTON INDUSTRIAL - MEX/TENTA -MKPX224K275A01 -  XRY MKP X2 Capacitor, AC.

Metalized Polypropylene capacitors have the ability to “repair” themselves. This so-called "self-healing" ability applies when a capacitor with metallized films has the foils exposed to each other due to dielectric breakdown under voltage stress.

Capacitors for Electromagnetic Interference Suppression Class X2

Ratings: 0.22uF 275VAC.

Tolerance: 10%

Radial EMI/RFI Suppression Capacitor.

Material: Non-Inductive Construction, Metallized Polypropylene film with flame retardant plastic case and epoxy resin seal (UL94V-0).

High Pulse Withstanding.

Self-Healing Property.

Excellent High Frequency Characteristics.

Excellent Temperature Characteristics.

Approximate Dimensions; 15.8mm Tall, 25mm leads with 23mm Lead Spacing.

Applications: General Industrial Applications, Antenna-coupling and line-by-pass, Radio and across-the-line interference Suppression, Spark killer circuit, Switching Power Supplies, EMI filters, Audio and TV Circuits, Lighting.

RoHS Compliant.

Alternates: MKP-X2 2.2/275/20 PCM27.5, MPX224K305G

Package of 10.

Calrad - 95-879 Alternator noise / whine filter.

Alternator whine in your car stereo can be an elusive problem. As the RPMs of your vehicle rise, the volume of the alternator whine can increase as well. Identify the underlying cause of the whine to silence it for good. There are several possible causes of alternator whine and troubleshooting is the best way to isolate it. If proper grounding and wire placement does not eliminate the noise, a filter may be the ultimate resolution.

Automobiles equipped with alternators can reduce annoying noise on amateur or CB gear with use of this easy-to-install noise filter.

Maximum current 25A.

Made in Japan.