Motor Starter Relay

UNI9-7 - Universal Starter Starter Solenoid Relay Assembly, 3-Terminal.

Coil Voltage: 12VDC

SPST Normally Open Contact

Coil Resistance: 4 ohms,

Coil Current: 3 Amps, Momentary Duty.

Two Large Copper Contactor Terminals: 5/16-24,

Single Coil Terminal: 10/32

Grounded Case/Base.

Heavy Duty 

One side of coil internally connected to integral mounting bracket, very high resemblance to those used in Ford Automobiles, Trucks, Tractors, and/or Marine. Replacement Solenoid for Oliver Tractors, Indust/Construction, International Harvester, & Allis Chamers applications.

ESSEX RBM CONTROLS - 91252-121, Potential Start Relay.

Motor Start Relay

115 VAC 60 Hz, 

1/12 HP,

SPST Normally Open Contact.

Three terminal device (with #1 a no-connect tie point.)

Terminal #4 is connected to one end of the coil and one side of a normally open contact. Terminal #3 is connected to the other end of the coil.

Terminal #2 is connected to the other side of the normally open contact. Coil current exceeding 5 amps will cause the contact to close until the current falls below 3 amps.

In a typical application, the #2 terminal connects the starting winding on a split phase AC motor, and the run winding is connected to the #3 terminal.

When the AC voltage is applied to #4 terminal the initial current drawn as the motor comes up to speed applies the voltage to the starting winding until the motor reaches a running speed and a lower current level.

Genuine Essex RBM Controls Relay - New Old Stock