Ferrite & Toroid Core

Universal Toroidal Transformer.

Multi-tap turn toroid core.

Overall 60.3mm (2.376") D round x 22.6mm (0.892") thick with 3-1/2"

3 varnished leads each about 0.033 and 0.040 = 6 leads.

Learn More

Magnetics - 2D10-55115-A2-2 Toroid Inductor, Core.

Toroid 3/8" x 1/4".

Customer research indicates these are Coated Molypermalloy Powder (MPP) toroid. 

No other information available.

Vintage - New Old Stock

Package of 10.

Learn More

Ferrite Toroid Core 5/8" x 1/4" Learn More

Inductor, toroid. Inductance: 18.85uH. DC current: 2.8Amp. DC resistance: 44.8 Ohm. Tolerance: 10%. Case: radial leads, unshielded. Dimensions: 15.88mm long x 8.89mm wide x 6.35mm high. New. Learn More

TDK - H7C1PQ2020Z - PQ2020 - Ferrite Pot Cores 2/SET

Ferrite Pot Cores for Switching Mode Power Supplies Driven at High Freq's.

Dimensions: 20mm Long x 14mm wide x 10mm High

Genuine TDK - New Old Stock

 

Learn More

TDK - H1A P18/11 Z 52H - Ferrite, Core.

RFI Pot Core.

Dimensions: Round 0.708" D (18mm) x 0.207" High.

Center Hole.

Package of 2/set.

Alternate: 1E82X535

Genuine TDK - New Old Stock

Matching shield available, please call.

Learn More

STEWARD FERRITES - 39G3449 - Inductor, Toroid Ferrite Core.

OD: 22.1mm, ID: 13.5mm x 6.3mm Thick.

Color: Grey.

Note: Steward is now Laird Technologies

Learn More

Inductor. EMI suppression ferrite test & design kit. Note: Possibly a complete full kit.

Learn More

Inductor. EMI suppression ferrite test & design kit. Note: Possibly a complete full kit.

Learn More

STACO - 829-0088 Universal Toroid Core, Transformer. 50VA, Open Frame.

Primary is 550 turns of #29 enameled copper wire wound around a 2.8" OD 1.5" high, tape wound, iron core.

120VAC Pri windings. PriRes=23-Ohms.

Spec sheet #155 available.

Similar to GenRad's old Variac or Superior's Powerstat.

Learn More

PREM - 855A03 - Inductor, coil. Tuneable, with Dial.

Mount: 3 Pin PCB.

Dimensions: Overall 7/8" x 7/8" x 1-3/16" high.

Learn More

Inductor. Package: 4 pin SMD. Learn More

EMI Suppression Filters. Chip ferrite bead. Impedance: 220 Ohm 2Amp. Package: SMD 0805. Note: Manufactures 7" reel is double marked BLM21P221SGPTM00-03. Package of 25. Learn More

Inductor, ferrite. Set in a 4 Dip PCB mount housing. Dimensions: 0.472" wide x 0.440" deep x 0.486" high. Learn More

MICROMETALS - T130-0 Inductors, RF toroids.

Iron Powder Cores.

AL= 1.5 (nH/N2) +/- 10%

Material: Phenolic

OD = 1.30 / 33.0 mm +/- 0.02 in

ID = 0.780 in / 19.8 mm +/- 0.02 in Ht = 0.437 in / 11.1 mm +/- 0.025 in AL= 1.5 +/-5%

50 MHz - 350 MHz 

Genuine MicroMetals product

Recommended uses: Line filters, Power conversion

Additional Information: http://c1170156.r56.cf3.rackcdn.com/UK_MIS_PC_Series_Issue_L_DS.pdf

Learn More

MICROMETALS - T106-0 Inductors, RF toroids.

AL=1.9 +/- 5 %

RF Phenolic Toroid

Dimensions: 1.06" OD x 0.437" high, with 0.57" ID and 0.260" thick walls.

Genuine MicroMetals product

Recommended uses: Line filters, Power conversion

Additional Information: http://c1170156.r56.cf3.rackcdn.com/UK_MIS_PC_Series_Issue_L_DS.pdf

Learn More

Inductor, ferrite. "E". Dimensions: 0.986" (25mm) wide x 0.649" (16.5mm) deep x 1.916" (48.6mm) high. Top of ferrite and lower sections are only 0.306" (7.7mm) high. Each with an inside curve toward the center. Center scection of ferrite is round 0.653" (16.5mm) D. Note: Sold one @ $4.00 USD. Learn More

ISKRA FERITI - FP15G100 51-00 - Ferrite Rod. Perfect for Amateur and Crystal Radio.

The Iskra Feriti (Iskra Ferrites) company has more than 40 years’ experience in the production of ferrite materials and products.

Ferrite Rods, Bars, Plates and Tubes. Ferrite rods, bars, slugs, plates and tubes are primarily used as magnetic cores in radio antennas, chokes, inductors and filters. In radio antennas, ferrite rods are useful from VLF spectrum to VHF spectrum. The advantages are small size, high Q and compactness. They are used for their properties of high magnetic permeability coupled with low electrical conductivity (which helps prevent eddy currents).

Ferrite Rod Core is a cylindrical ferrite core, can be easily assembly with a spring coil or wind wire directly. It's widely used for radio antenna, LF/HF RFID antenna, choke coil, inductor, DC power filter, DC signal filter and transformer. Due to the open magnetic structure, the core can accept large DC bias before saturate. The rods are design to use for MW and shortwave antenna coils; in high frequency applications they have low loss characteristics.

Large ferrite rod made for radio "Loopsticks"

Authentic Vintage Iskra Ferite - New Old Stock

Dimensions: 10mm D x 50.8mm long. (0.394" X 1.969")

Additional Information: http://www.holmmagnetics.dk/html/kurver.html

Learn More

FERROXCUBE - 3019PL00-3C8 - Ferrite, Pot Core, Uncoated.

Dimensions: 9.4mm D round x 30mm long with center hole.

Color: Gray.

Cross: 1102-00665-028.

Package of 2.

Learn More

FERRITE 1" OD POT CORE - Set of Two - New Each 0.315"high Learn More

FAIR-RITE - 0443164051 - Filters, Ferrite.

Ribbon Cable Line Filters.

Split bead and housing assemblies.

Dimensions: 2.5" wide x 1.11" x 0.65" when closed.

Heavy Duty.

Learn More

Laird - DM STEWARD - STE28S0670-000 - 28S0670-000 - Ferrite.

One Piece Split Core Ferrite Suppressors for Flat Cable 150ohms 100MHz 12.5mm Inside Slot

Impedance: 60 Ohms @ 25 MHz, 150 Ohms @ 100MHz, 310 Ohms @ 300 MHz

Core Material: 28  

Operating Temperature: -40 C to 125 C         

Has two rounded edges on opposite side which are 0.095" wide x 0.59" deep x 0.13" tall.

Dimensions: Inside Length: 12.5 mm, Outside Length: 17.02 mm, Outside Width: 14.99 mm, Inside Height: 0.51 mm, Outside Height: 3.4 mm  

Laird Technologies Acquires Steward, Inc. and Its Subsidiaries in 2006

Newark P/N 32AC5311

New Old Stock

Made in USA

Learn More

Ferrite, core. Pot core. Gapped. Dimensions: 11.1mm D x 3.4mm high. Set of 2. Learn More

Inductors, ferrite. Coil form on a board. Learn More