Pressure Sensor

HONEYWELL Micro Switch - 26PCCFA1D Presure Sensor, PCB Mount.

The 26PC Series Miniature Pressure Sensors are small, cost-effective devices intended for use with wet or dry media. These sensors feature proven sensing technology that uses a specialized piezoresistive micromachined sensing element to offer high performance, reliability, and accuracy. Each sensor contains four active piezoresistors that form a Wheatstone bridge. When pressure is applied, the resistance changes and the sensor provides a milliVolt output signal that is proportional to the input pressure. The low power 26PC sensors are designed to accommodate pressures from 1 psi to 250 psi and have an operating temperature range of -40 ºC to 85 ºC [-40 ºF to 185 ºF].

Status: Discontinued

Pressure Range: Differential, 0-15 PSI

Seal Material: Flurosilicone

Pressure Type: Straight Port

0-100MV Output.

Non-Temperature Compensated Output

Silicon Sensor Chip

10-16VDC.

Dimensions: 1.35 Lx 0.5W

Operating Temperature: -40 C to 85 C

Gage 0.86 L, 4-leads.

Applications: Medical, Industrial, & Commercial.

More Information: https://sensing.honeywell.com/honeywell-sensing-trustability-board-mount-pressure-sensors-tsc-nsc-datasheet-50064366-d-en.pdf

Proudly Made in USA

ASHCROFT - 1003 - 2 Inch Diameter.

Scale: 0-100 PSI (6.9 bar)

Commercial Pressure Gauge

Thread Connection: 1/4 NPT Brass Back Port

Case: Aluminum

Dial Diameter: 2" (50.8mm)

Accuracy:  +/-3-2-3 Percent

Lens Material: Polycarbonate

Made by Dresser industries, Berea Kentucky USA.

New Old Stock

Alternate: 662876000548

VALIDYNE - DP45-16-2114 - Gould 369500-57035 - Transducer, Low Differential Pressure.

The Validyne DP45 Very Low Differential Pressure Transducer is designed for extremely low pressure measurement in the order of ±1 inch water column. This instrument is used extensively in connection with flow measurements where dynamic response at low flow rates is required. Dynamic line pressure effects are minimized due to the combination of low internal volume, symmetrical construction, and small volumetric displacement inherent in the DP45 design.

All surfaces exposed to the media are corrosion resistant steel. The design and construction of the DP45 permits the user to disassemble the instrument for cleaning, diaphragm replacement, or changing the transducer range. The transducer range is changed by substituting a different sensing diaphragm chosen from the Diaphragm Selection Chart on the reverse side of this sheet.

Used with a typical Validyne carrier demodulator, pressure inputs as low as 0.6 in. H2O will produce up to a ±10V output. The exceptionally low acceleration sensitivity of the DP45 ensure accuracy under all types of mounting conditions.

• Low range: ±0.6 to 90 in.H2O FS
• Low internal volume
• Symmetrical construction
• Small volumetric displacement
• High natural frequency

3.5CM.

Electrical Connector PT06A-10-6S

Mounting: Three Holes 6-32unc-28X.20 Deep ON 1.75- Diameter.

Dimensions: 57mm Diameter (2.24")

Additional Information https://www.validyne.com/product/dp45_low_pressure_variable_reluctance_sensor/

Alternate P/N: Gould 369500-57035.

Made in USA - Factory New With Specifications & Installation Drawing

Meriam - 1203-L776-11G - Transducer.

Precision 0-250 PSIG.

6 Pin.

JUMO - 4AD30-242 - 4AD30-242/079/093 Transducer, Pressure.

Data Sheet 4354-9311103

Status: Discontinued

0-3000 PSI, IP65

1/2-14NPT

4/20mA-Output.

Piezo -Resistive

Surface Mounting Case - Front Flush Pressure Connection

6.5"Long x 1"OD 13-30VDC.

Additional Information: https://docs.rs-online.com/bef8/0900766b814602a1.pdf

NEW - Made in Germany

Hottinger Baldwin Measure HBM - PSB-10201 330#

HBM strain gauges, sensors, transducers, data acquisition systems, measurement and DAQ software make them an undisputed leader in the field of measurement instruments.

330# NEW LOAD CELL

18" Square PLATFORM

One Load Cell in Each Corner

Very Durable - Commercial

Stainless Steel

New in Box

Germany

HONEYWELL - 26PCAFG6G Vacuum Sensor.

The 26PC Series miniature pressure sensors provide reliable gage pressure sensing performance in a compact package. The sensor features a proven sensing technology that utilizes a specialized piezoresistive micro-machined sensing element. The low power, non-amplified, compensated Wheatstone bridge circuit design provides inherently stable mV outputs over 1.0 psi through 250 psi sensing ranges.

26PC Flow-through series

Flow-through or Vacuum

Signal Conditioning: Unamplified;

Pressure Range: 1 psi

Port Style: Flow-through.  

Note: pressure.

Made in the USA.

BRUEL & KJAER - 4371 - PZT Charge Accelerometer.

Type 4371 is a piezoelectric, DeltaShear, Unigain accelerometer with side connector. Type 4371 features 10-32 UNF receptacle for output connection and can be mounted on the object by means of a 10-32 UNF threaded steel stud.

Frequency range: 0.1 – 12600 Hz

Temperature: -74 – 250 C

Weight: 11 gram

Sensitivity: 1.0 pC/ms^-2

Residual Noise Level in Spec Freq Range (rms) ±: 0.24 mg

Maximum Operational Level (peak): 6000 g

Electrical connector: 10-32 UNF

Mounting: 10-32 UNF

Output: Charge-PE

Unigain: Yes

Triaxial: No

TEDS: No

Resonance frequency: 15 kHz

Maximum Shock Level (± peak): 20000 g