Featured Products

Connector, header. Housing gender: plug. Contact gender: male. Circuit count: 10. Mounting type: PCB, straight. Pin spacing: 0.2SP. Connection: PC pins. Outside dimensions: 1.995" long x 0.308" wide x 0.473" high. Note: Open ended. Learn More

Western Electric - 242CM - Connector, Audio.

Heavily Insulated, Singly-Mounted Jacks. Solder-type terminals are arranged to accommodate two No. 19 B & S gauge wires. Arranged for use with a No. 310 or similar type plug.

1/4-inch phone jack with integral mounting tab.

Mates with a tip-collar-ring type (stereo) plug.

There are 7 wirewrap connections on the rear.

There are three normally closed contacts when no plug is inserted.

All three open when the plug is inserted.

One contact is isolated, one is connected to the tip and one to the collar.

The jack mounts in a 0.450" clearance hole and is held in place by a screw through a nearby 0.156" hole.

The jack extends approximately 3-1/4" behind the mounting panel.

Western Electric Specification Sheet atttached.

Vintage Genuine Western Electric Antique Phone Jack - New Old Stock.

Proudly Made in USA

Learn More

Western Electric - 351B - Telephone Accessory.

Phone Key assembly with attached (4) lead switches.

Test plug for the vertical assembly on a 320-series (second generation) XB switch.

Learn More

Western Electric - 328D - Connector.

600 Ohm

Material: Bakelite

Genuine Vintage Western Electric - New Old Stock - Rare

Dual Male 1/4 Plug Terminator.

Learn More

Western Electric - 309 -  Telephone Accessory.

Single Plu - 3 contacts 3 Conductors

3/16" Patch Cord Phone Plug.

Red.

Dimensions:  3 1/16 x 1 3/32 x   9/32 x 3/8

Applications: The 309 goes into, among others, the 246-type jack. The 309 was used singly, or in jack panels and PBX's that needed high density numbers of jacks, such as the 608A & D cord boards. Rare plug can be used as headphone, mic, aircraft, Ham, patch cord...etc.

New Old Stock

Alternate: TRS 3/16" Collins Patch Cord Plug

Proudly Made in USA

Learn More

Telephone adaptor. Learn More

IC. Clock driver. Package: 18 Dip. Learn More

IC. Peripheral controller, address mark (AM) detector. Case: 20 Dip. New, older stock. Learn More

Weidmuller - TS02-08 - Connector, Terminal Block.

Circuit Count: 2 Position.

Pitch: 5.0mm.

Insulation Voltage: 250V.

Mounting Type: PCB pins.

Outside Dimensions: 0.600" long x 0.5" wide (deep) x 0.753" high.

Snap together for additional lengths.

Right Angle.

Color: Orange.

Made in Germany

Learn More

Starter, Magnetic, Size 0, 3PH. Coil: 120VAC 60cy. Mount: Panel. Open frame. One normally open auxiliary contact, 2 poles with overload assemblies (overload heaters are not included). Learn More

Diode. 30Amp 100V. Center-tapped. Non-controlled avalanche. Case: TO-3 steel. New. Note: Silicon. Learn More

NEW 4-POS (F) PLASTIC CONN CONN C-GRID MALE 4POS HOUSING Learn More

CONN HOUS 2POS C-GRID "G" SERIES Learn More

WABASH - 1992-2-1 Relays, Reed.

Sealed 6 pin Metal Can.

Learn More

Diode. FWB, full wave bridge rectifier. Working voltage: 400V. Current rating: 10Amp. Single phase. Case: TO-3, hermetically sealed. Used, removed from equipment. Learn More

WAGO - 279-317 Terminal Plate, End and Intermediate Plate only.

Size: Height 27 mm, Width 2 mm (0.079")

flamability Rating: UL94V-0

Color: Orange.

Learn More

WAGO - 249-116 - Connector, Terminal Strip.

The 249-116 from Wago is a 6mm wide grey colour screwless end stop for use with terminal blocks.

Screwless End Stop.

Size: 6 mm / 0.236" wide.

Dimension is 6mm x 28.2mm x 45mm (W x H x D)

Mount: Din Rail.

Color: Grey.

Alternate: Newark 28K2138, Digi-Key 2946-249-116-ND

Learn More

WAGO - 209-703 - Connector, Terminal Strip.

WSB Quick Marking System Perpendicular.

Size: 4 mm width, (11-20)

Marking method: Thermal transfer

Marking: 11 … 20

Marking (number): 10

Marking Direction: Vertical Marking

Marking Color: Black

Marking Type: Numbers

Marking representation Consecutive numbers per strip

Delivery form: Marker card

Delivery form configuration: 10 strips with 10 markers per card

10 strips of 10 markers per strip (100) per card consecutive numbers each strip.

Alternate: 60K7273, 2946-209-703 ND

Learn More

WAGO - 209-702 - Connector, terminal Strip.WSB Quick Marking System Perpendicular.

Marking method: Thermal transfer

Marking: 1 … 10

Marking (number): 10

Marking direction: Vertical marking

Marking color: black

Marking type: Numbers

Marking representation Consecutive numbers per strip

Delivery form: Marker card

Delivery form configuration: 10 strips with 10 markers per card

Size: 4 mm width, (1-10)

10 strips of 10 markers per strip (100) per card consecutive numbers each strip.

Alternate: Newark 78H0731, Digi-Key 2946-209-702-ND

Learn More

WAGO - 208-002/676-000 Connector, Rail Mount Terminal Block.

14 x 2 Conductor, 16-28AWG, 10Amp.

Mount: Through Hole.

Mounted on 3'' long DIN rail with End Blocks.

Dimensions: 1.7'' x 1.5'' high.

End Caps o din rail.

Made in Germany

Learn More

Connector, solderless terminals. Uninsulated ring. Wire size: 8. Screw: #8. VersaKrimp. Package of 50. Learn More

Wago - 236-211 - 809-236/078 - Connector, Terminal Block.

PCB TERMINAL BLOCK, 2.5 MM, PIN SPACING 5/5.08 MM

PCB Terminal Strips with CAGE CLAMP^® connection, screwdriver actuation parallel or perpendicular to conductor entry

Operating Tools for factory wiring

Circuit Count: 10 Position.

Mounting Type: PCB.

Voltage: 300 V

Current: 10 A

Solder Pin Length: 3.6 mm

Solder Pin Length: 5.5 mm

Connection: Right Angle Wire Entry.

Outside Dimensions: 52.3mm long x 14.3mm wide x 13.2mm above board.

Note: These terminal strips are actually 10 pieces 1P all snaped together to make a 10 Position T-strip, each with end pieces. 10 236-101 Snapped together make one 236-211

Alternates: Newark 28K9514, Digi-Key 2946-236-110-ND

 

Learn More

Vishay - 1N4678 Diode, Zener.

Voltage: 1.8V.

Power: 1/2 Watt.

Tolerance: 5%.

Current Rating: 120mA.

Case: DO-35 Axial Leads.

Package of 10.

From: Manufacture T/R.

Learn More

DC-DC CONVERTER BOOSTER MODULE 24VDC IN (18-36VDC) 24VDC OUT 150W / 6.25Amp NO LOGIC CIRCUITRY MUST RUN WITH THE VI-2W3-05-B1 FOR BOOSTING THE OUPUT POWER W/ Chassis-mount module housing features screw/lug Wiring Interface Dimensions: 4-9/16" L x 2-3/8" W x 1-1/8" HIGH Identical in specs to the VI-BW3-CV-B1 Learn More