Power Transformer

Transformer, power. Power: 12VA. Pri/Sec: 115/230 to Dual 8V. Secondary: 750mA each. Construction: Low Profile semi-toroidal hum-bucking. Mounting: PCB. Dimensions: 35mm above board x 48mm x 57mm. Note: 8VAC at 1.5A or 16VCT at 750mA. For quantity price breaks, please call to order. From: 24/Case. Learn More

Triad/Magnetek - F-41X Transformer.

25.2VCT@ 2Amp. 

Maximum Power  50.4 VA

Voltage Regulation  10% Typical 2 Full load to no load

Filament transformer red-red/yel-red.

115VAC Primary black leads.

Dimensions: 2.593 x 4.00 x 2.250" high with 2 hole mounting flange 3.56"spacing.

Hipot of 1500B between primary and secondary windings and core 

Weight: 2.2 lbs.

Learn More

Signal Transformers - 241-4-1775 Power Transformer, Secondary 15VAC at 400mA. 115V Primary. Split-bobbin, high isolation. low capacitive coupling. Dimensions: 2.37" long x 1.25" wide x 1.37" high. Mounting holes are 2" apart. Primary: 5" wire leads. Sec: 8" wire leads to 3-pin molex plug. Weight: 7 oz.

Learn More

Radio Transformer Factory New Military Fully enclosed NSN 5950-005019442, (LOCKHEED MARTIN 6096978-1)Double marked W8885 Learn More

Military Enclosed TransformerNo other spec's avail. Marked Lockheed Martin 6096979-1 andElectro Networks W8860 Learn More

Military Enclosed TransformerNo other spec's avail. Marked Lockheed Martin 6096977-1 andElectro Networks W8860 Learn More

Military Transformer Input 440V, 9-LeadsLockheed Martin 6096882-1, Overall 1.074" dia round x 0.5" high, PCB Mountable Learn More

Transformer, step down. Power: 25 VA (est.). Pri/Sec 120V-11V-22V . Secondary: 1A (est.) each winding. Turns ratio: 12:1 and 6:1. Construction: e-laminations. Connections: wire leads. Package: open laminations. Mounting: brackets. Dimensions: 3x2-3/4x2 inches. Weight: 1.7 lbs. Two separate secondaries, 11V and 22V. Note: New older stock. Learn More

15KVA Transforrmer PRI. 480V SEC. 120/240VAC 60 cycle SINGLE PHASE. Enclosure type 3R - pri. taps 456, 468, 480, 492 & 504. weighs about 215# approx. 16" X 13" X 10.5" looks in good condition. Learn More

Better Coil and Transformers Company - 55-86912-1/605P3

Transformer. 30V 15VCT 2A, +5V@2A.

Dimensions: 2.6 x 2.5 x 2.25" high.

Open frame.

Dipped in moisture resistant varnish.

Weight: 2 LBS. 

EIA Code 831-8431. 

EIA (Electronics Industries QAssocciation) code 831 identifies manufactuere "Better Coil and Transformers Company" 

Learn More

Transformer, inverter. 250VDC 60mA out. 28VDC in. Package: round 10 pin. Dimensions: 1-5/16" D x 1/2" deep.

Learn More

Transformers, dual. AC output 18VAC at 1.35Amp and 8.5VAC at 150mA. ICC-2-1500-1-CL2. Complete with a 4 foot, 2-conductor power cable. Output cable approx 7.5' with a 4-pin connector. Mount: Desk top. Listed: Ul/CSA. Learn More

Transformer. Tapped outputs: 11.1VDC 4Amp, through practically any voltage up to 33VDC 2Amp. Mount: Panel. Dimensions: 3-7/16" x 2-13/16" x 2-3/4". Weight: 3.8 lbs. Used/Removed from equipment. Excellent condition. More info: http://www.stancor.com/pdfs/Catalog_2006/Pg_006_7.pdf Learn More

Transformer. Dual primary: 105/210V. Secondary: 9.5VAC 1.75Amp and 24VAC 1.75Amp. Unshielded with terminal boards. Learn More

HOBART TRANSFORMERS - PD-6805A Transformer,

Ideal for dual DC power supplied, controls and instrumentation

Two Primaries: each rated at 115VAC and 50/60 Hz

Two Secondaries, each rated 34VCT @ 0.5A

Series and Parallel connections of the paired windings allow for 115 or 230 VAC input and 34VCT @ 1A or 68VCT @ 0.5A.Primaries are numbered 1-2 and 3-4;

Secondaries are numbered 5-6-7 and 8-9-10. Winding polarities run in ascending numerical winding order.

Connect 2-3 to input 230VAC between 1 and 4 or 1-3 and 2-4 to input 115VAC.

Likewise, connect 7-8 to output 68VCT between 5 and 10. and 5-8, 6-9 and 7-10 to output 34VCT.

Dimensions: 3 1/8" X 3 1/4" x 2 3/4"

UL Recongnition - UL-1446

Weight 1.7 lbs.

Learn More

Transformer. Dual 60V 200mA. Useful as an isolation transformer at 24 watt. Mount: PCB 8 Pin. Learn More

Transformers. 36V 250mA. Mount: chassis, open frame, 4 wire. Dimensions: 2-1/3" wide x 2" deep x 2" high with 2-7/8" mount centers. Learn More

Transformer. Reliance 64977-52R. 9-wire. Learn More

Transformers, power. 5V at 1Amp. Marked 3527348. One side of the 5V secondary is soldered to frame externally, removable. Dimensions: 1.8" x 1.2" x1.4" high with 3 wires. Weight: 4oz. Learn More

Pri: 115V 50/60Hz Open Frame mounts on 2" centers (two holes 2" apart) 1.7 x 1.25 x 1'4" tall - New PC mount Learn More

Sola HD 23-22-112-2 120VA CVS Voltage Regulator.

Transformer, constant voltage. 120/240 VAC Primary: 95-130V x 190-260V 60Cycle. Secondary: 120V 60Cycle. 1Phase 120VA. Packed weight approximately 16 lbs. Height 8" (203.2mm), Width 4" (101.6mm), Depth 5" (127mm). 

Superior voltage regulation of ±1% sets the CVS series apart
from other power conditioning technologies on the market.
Extremely tight regulation is accomplished by SolaHD’s ferroresonant transformer technology. The CVS recreates a well
regulated sinusoidal waveform that is well isolated from input
disturbances including:
• Impulses • Swells
• Brownouts • Sags
• Severe waveform distortion
No other power conditioning technology provides as
complete a solution against these power quality
disturbances. The CVS series is ideal for applications
where even a small change in voltage level can lead to
unscheduled downtime, misoperation, incorrect data or
scrapped production.

Features
• Superior voltage regulation of ±1%
• Surge protection tested to ANSI/IEEE C62.41,
Class A & B Waveform
• Harmonic filtering
• Hardwired
• Acts as a Step-up/Step-down Transformer
• Galvanic isolation provides exceptional
circuit protection.
• 25 year typical Mean Time Between Failure
• No maintenance required

Applications
• Industrial automation and control equipment PLCs
• Analytical laboratory and factory automating
equipment
• Photo processing equipment
• Sound/recording systems
• Photographic enlargers
• Broadcast equipment
Related Products
• On-line UPS (S4K Industrial)
• Surge Protection
• Three Phase Power Conditioners
• Active Tracking® Filters

Learn More

Sold for the 1.1VA Split Bobbin PCmount Dual Output Transformer on the board made for Royal Streetlamps measuring 2.8" x 1.7" x1.3"tall. Has a full wave bridge and four resistors, 3 wires marked ON - C - DIM. ST-3-10 Xfmr: Pri:115V Sec:series 10VCT 110mA Out:parallel 5V 220mA. Xfmr:35x29x24mm Learn More

Transformer. Primary: 115VAC. 4.6V No Load. Open frame. Learn More

Transformer, Dual primaries for 120V,220V,or 240V operation, three center-tapped secondary outputs of 36VCT/1.25A, 35VCT/1A, 28VCT/1A, electrostatic shields on both winding assembles, tape-wound core. Dimensions: 4" X 3" X 2.6" (approx). Weight: 4 lbs and 4 oz, unpacked. Learn More