Key Features
- Item: Panel Meter Accessories
- Connection: Screw Terminal
- For Use With: CUB4, CUB5, DT8
- Accessory Type: Micro-line Power Supply
LUCIDYNE - 1022A - AUTOMATIC VOLTAGE CONTROL BOARDS
900619-101 PC BD 900619
Rwmote Front Panel
Note: Lucidyne acquird by Microtec
Learn MoreSiemens Furnas - 41NB21AG - Relay, AC.
Status: Discontinued
Air Conditioning Definite Purpose Magnetic Contactor
Unlike General purpose contactors, which are rated typically based on HorsePower (HP) of the motor, Definite Purpose contactors are rated on Motor Full Load Amps (FLA).
Series A, LI Pilot Pole, Open Frame
Standard Duty 240 VAC Max.
Contactor: 120/240VAC 25A.
Contacts: 2P NO, 1P NC
Locked Rotor Amps: 150A
Welded Resistant Silver Cadmium Oxide contacts
Reinforced Thermoset Polyester Housing
Plus Aux NC contact in center.
Coil: 208-240VAC 50/60 Hz, 600 Ohm.
Connection: Screw Terminals with 1/4" Copper Lugs with Solder Holes.
Electrical Conf: DPST Normally Open.
Mech: Two Mounting Slots 1.7" spacing.
Dimensions: 2.5" x 2.7" x 2.7"H.
UPC 783087 071759
Alternate: D54790-135
Weight: 10 oz.
Approvals: UL, SAE
Series A, 54790-135
Applications: Typical applications include cooling towers, refrigeration equipment, and commercial HVAC. Air Conditioner, NEMA
contactors provide the switching (on/off) function.
Note: Designed with a low drop out voltage making them ideal for air conditioning, heating and refrigeration applications. Space saving dimensions allow for smaller panels and more wiring room. The combination of multiple mounting holes and slots allows these contactors to be fastened onto panels and provide interchangeable mounting with many competitive contactors.
Siemens starters and contactors includes replacement products for parts formerly produced by Furnas Electric, including Furnas contactors and motor starters.
Made in USA
New Old Stock in Manufacturer's Packaging
Learn MoreSKAN-A-MATIC - S28002 - Photoelectric, Sensor / Wafer PhotoDetector Sensor. New
The S28 series skanner is a specially constructed LED Sensor designed to detect wafers for the semiconductor industry. polished and unpolished wafers can be detected from the same sensing point.
Operating Voltage: 30 VDC Max.
Spectra Response: 910 nm peak, filtered to respond to less than 5% at 750 nm and less than 0.1% at 700nm.
4 Conductor, 26 GA, Teflon Covered Cable with shielded photodetector leads and overall shield.
LED Skanner
Operating Distance 0.050".
Bottom Mounted Cable.
Note: LED must be current limited, 40mA max which will result in a forward voltage drop of 1.0-1.6VDC.
New Old Stock in Manufacturer's Packaging
Learn MoreRED LION CONTROLS - MLPS0000
Input Power: 115/230V switchable 50/60Hz 3VA
0-60 deg C.
Output Power 12VDC 80mAmps
2 hole mounting
Dimensions: 67.3mm x 47.2mm x 32.5mm High
New Old Stock
Learn MoreEATON CUTLER HAMMER OPCON - 8211A-6501 - Plug-in Logic Module, Time Delay Logic Card.
The 8211A Time Delay is an optional logic card for Opcon's 1411D and 1311D Control units.
50 ms to 5.0 sec.
LT or DK mode.
Factory New
Made in USA
Learn MoreEATON CUTLER HAMMER OPCON - 8211A-6501 - Plug-in Logic Module, Time Delay Logic Card.
The 8211A Time Delay is an optional logic card for Opcon's 1411D and 1311D Control units.
50 ms to 5.0 sec.
LT or DK mode.
Factory New
Made in USA
Learn More