Audio Equipment

Connector, audio. Miniature inline jack, shielded 3.5mm. Solder terminals. Learn More

Connector, audio. Male 2 pin. Learn More

Calrad - 95-879 Alternator noise / whine filter.

Alternator whine in your car stereo can be an elusive problem. As the RPMs of your vehicle rise, the volume of the alternator whine can increase as well. Identify the underlying cause of the whine to silence it for good. There are several possible causes of alternator whine and troubleshooting is the best way to isolate it. If proper grounding and wire placement does not eliminate the noise, a filter may be the ultimate resolution.

Automobiles equipped with alternators can reduce annoying noise on amateur or CB gear with use of this easy-to-install noise filter.

Maximum current 25A.

Made in Japan.

Learn More

Calrad - 10-113 - Audio Microphone Splitter.

The Calrad 10-113 Microphone Splitter splits input of a single microphone to two different outputs, both input and output signals may be used to provide separate isolated feeds to both a house and monitor system, P.A. recording system or similar application where double outputs are required. No Power required.

Specifications:
Input Impedance: 600 ohm
Dimensions: 4 3/4" X 3 1/8" x 1 5/8"
Output impedance: 600 ohm
Frequency Response: 20-20k

Color: Black

RoHS Compliant

Learn More

Board. Electronic siren power driver. Output: 130db at 10 feet. Voltage requirement: 6-18VDC. Current consumption: 1.7Amp at 12V at 8 Ohm load. Two types of sound. 1, 2, or 4 speaker capability. Mount: easy-to-install adhesive. Dimensions: 3.853" long x 3.607" wide x 1.258" high. New. Learn More

Power amplifier. 6 Watt, 12-15VDC. Input sensitivity: 0.6V at full output. Frequency response: 10 to 25kHz. Power output: Mono: 15W at 8-ohm. Stereo: 6W. Input impedance: Low Z. Distortion: 1% @ full output. Learn More

Mic Page Screw Terminal Module. MP-S / TP-S or (MP-S / TP-5). Learn More