COMPONENTS CORP. - TP101-10 / TP101-10-T - PCB Test Points. Package of 100.

COMPONENTS CORP. - TP101-10 / TP101-10-T - PCB Test Points. Package of 100. The Components Corp. TP-101-10 (often ordered as part number TP-101-10-T) is a low-cost, through-hole printed circuit board (PCB) mounted test point jumper designed for board-level circuit troubleshooting and signal testing. Manufactured by Components Corporation, this component features a discrete loop profile that provides a secure, reliable anchor for test probes, spring clips, and scope probes. Technical Specifications • Lead Spacing: 0.100 inches (2.54 mm). • Above-Board Height: 0.200 inches (5.08 mm). • Wire Diameter: 0.020 inches (0.51 mm). • Contact Material: 70/30 spring-grade brass wire. • Finish: Matte tin plating over a nickel barrier. • Maximum Current: 2.0 amperes. • Mounting Requirements: Two plated through-holes (PTH), 0.040 inches (± 0.003") in diameter. Key Design Features • Detented Legs: The exclusive detented leg shape provides a snug, interference fit inside the designated PCB holes. This ensures the test point stays self-positioned and retained during aggressive wave soldering operations without extra installation steps. • Low Profile: It sits lower than traditional headers or secondary testing devices, allowing designers to add signal access points into high-density circuit layouts without requiring expensive board re-designs. • Safety & Retention: The defined loop shape eliminates sharp edges, preventing puncture wounds to technicians' fingers while firmly gripping spring-loaded test hooks. Additional Information: https://www.componentscorp.com/assets/files/TP-101.pdf Made in USA Package of 100.