HOFFMAN - FT015H-4 – Float and Thermostatic F&T STEAM TRAP, 15 psi, 406F, 5-1/2 In. L

HOFFMAN – 404210 - FT015H-4 – Float and Thermostatic F&T STEAM TRAP, 15 psi, 406F, 5-1/2 In. L The Hoffman Specialty float and thermostatic (F&T) steam trap, model FT015H, features a 1" trap connection in a same side, H-pattern configuration. This pattern allows steam to enter from either side of the trap, and the condensate to discharge from either the opposite or the same side of the trap. This configuration also allows for more flexibility when piping in. H Series F&T traps are continuous drainage and are designed for low, medium, and high pressure steam mains and come standard with stainless steel internal parts. The FT015H is cast iron and has a 15 psi maximum operating pressure. This trap has a capacity for 1,600 pounds per hour. The traps are designed for service on heat exchange equipment where there is a need to vent air and non-condensable gases quickly. They are recommended for modulating pressures where widely varying loads are present and are a good choice for their ability to vent air at very low pressures, handle start up air loads, and operate against back pressure. Type: Series H Steam Trap, (F)NPT Connections 1 in Max. Operating PSI 15 PSI End to End Length 5 ½” Condensate Capacity Lbs/Hr: 1,600 lb/hr Max. Temp. 406 Degrees F Type Float And Thermostatic Body Material Cast Iron Pipe Configuration (4) Pipe (2) Inlet and (2) Outlet, Pressure Air Vent Self-Adjusting Application For all Process Applications Requiring Removal of Condensate, Includes Air Vent (F)NPT Connections: 1 in Max. Operating PSI: 15 psi Condensate Capacity Lbs/Hr: 1,600 lb/hr Max. Temp.: 406 Degrees F Body Material: Cast Iron Type: Float And Thermostatic Pipe Configuration: (4) Pipe, (2) Inlet and (2) Outlet Pressure Air Vent: Self-Adjusting Application: For all Process Applications Requiring Removal of Condensate Includes: Air Vent Manufacture: ITT Hoffman specialty. Proudly Made in USA