DC Power Supply

Power supply. Output: +15VDC 4.5Amp. Input: 100/120/215/230-240V~. 1.7/1.5/0.8/0.8A~ 47-63Hz. Derate 10% for <58Hz operation. Open frame. NIB. Note: Maybe replaced with equal by Condor HN15-4.5-A+. More info: http://www.power-one.com/resources/products/appnote/n_linear_agencyapproval.pdf Weight: 7.4 lbs. Learn More

Power Supply. Switcher 28VDC 5.4A 150 watt. Input: 100-120/200-240V 4.6/2.3A 47-440Hz.Single output, remote sensing and trim. FlatPac, 9" x 2.5" x 1.3" high. With connection hardware and instructions. UL CSA TUV. Weight: 3 lbs. Learn More

Power Supply. +5V@80 Amp, -12V@10 Amp, +12V@10 Amp, +24V@2 Amp. Universal 115VAC/230VAC-Input. Switching. Open frame. No fan. Note: Used/Removed from equipment. Learn More

Power supply. 2.2VDC 400Amp. Switching. OUTPUT ADJUSTABLE +/- 10% 90-132 or 180-246VAC SINGLE PHASE INPUT. REGULATION: LINE- 5mV OR 0.1% LOAD- 10mV OR 0.2%. FOLDBACK CURRENT LIMITING - FORCED AIR COOLING - REMOTE SENSING - REMOTE PROGRAMMING - OVERVOLTAGE PROTECTED AND OPTION "F" EMI FILTER. NIB. Weight: 21 lbs (Packed).. Learn More

12VDC @ 1.3AMP Sealed modular PC mount 120/250Vac-In MFG. NEMIC/LAMBDA Learn More

Input: 44-58VDC 7.1A(max) 310W. Output:24VDC Adj: +/-5% Regulation 0.1% Line or No Load - Full Load. Remote Programming by External Resistor 1Kohm/V or 1-1 Voltage. Ripple & Noise: 10mVrms, 35mV-peak - Ruggedized. Input surge Protection, Input Polarity Prot., Overvoltage 26.5-28V Protection, Overload Protection Thermal And Electrical. Remote Programming, FUNGUS inert. 3-3/16 x 5 x 15" 15-pounds shipping. New w/ manual & schematic. Learn More

HP 6034L System DC Power Supply HPIB Auto-everything 200 Watt 0-60VDC @ 0-10A RAK MOUNT POWER SUPPLY - Digital Readouts Learn More

Power supply. AC Adapter. Input: 120VAC 60Hz 8 Watt. Output: 7.25VDC 150mA. Wall mount enclosed. Learn More

Power supply. AC adapter. Output: 8VDC 600mAdc. Input: 120VAC 60Hz 10 watt. Complete with attached 5.5 foot power cord and a 3.5mm plug. (Tip is negative). Learn More

Three Outputs: Two 12-19VDC at 10A each, Plus Two Large Screw Terminals "13VAC -4A." "VOLTS I/P: 187-264V AC" New. 15" long x 5"wide x 2.25" in black Shielded Enclosure. Learn More

Power supply. Triple outputs 2KWatt switching. Output: 5V 240Amp, 5.3V 60Amp, 12V@25Amp. V Adjustment: +/-10% min. Regulation: 0.2% + 5mV-max. Ripple: 0.1% or 10mV-RMS. Recovery time: to within 1% in 300 uSec. Input: 85-264VAC 47-440Hz. Efficiency: >75% - 82%. With Overvoltage, Overcurrent, Short circuit, Reverse voltage and Thermal protection. Remote sensing: Up to 5.0V drop. Switching freq: 200kHz. 73-190-6040CE. NEW boxed with Cert's and Installation & application notes. UL-CSA-VDE-TUV-IEC- 18 pounds each.

Learn More

Power supply, switcher. +3.3VDC at 19.5Amps and +12VDC at 3Amp Max. 82Watt Max OUT - INPUT: 100-240VAC~2.3A 60/50Hz 6" x 4" x 1.3"High Weighs just under one pound. 2-pin Input and Three Terminal Output, prewired with Four +3.3V leads, Four Black Common leads and two +12V leads into 12-pin connector. Two pin Power Input - Beautiful NEW Switcher !!! UL-CE-TUV APL Approved.

Learn More

AC adapter. Output: 16VDC 800mA. Input: 120VAC 0.2Amp 60Hz. Enclosed. Complete with attached 7 foot cord and 5.5mm plug. Learn More

15VDC 11AMPS POWER SUPPLY - Used - 12"L x6-3/4"Hx4-3/4"W Approx 25# shipping Learn More

Power supply, AC adapter. Output: 6VDC 400mA. Input: 120VAC 60Hz 4.5 watt. Wall mount/plug-in. Class 2. Center pin positive. Learn More

Power Supply. Output: 5VDC 500mA. This board uses a Signal Transformer ST-5-16 split/tran Class B-3 Transformer. Fused primary. Has four 1/4" male QC terminals. LM317T VR. Dimensions: 2.1" x 4.4" x 1.5" high. Weight: 12 oz. More info: http://www.signaltransformer.com/sites/all/pdf/ST.pdf Learn More

Open frame Switching Power supply. 9-pin terminal board, 1+2, 3&4, 7+8 jumped, no hookup instructions. Replaceable ceramic 3AG fuse. New, older stock. 6.5" x */5" x 1.75" black aluminum case/frame. Only 1.8 pounds. Learn More

Power Supply, switching. 5-Outputs: 24VDC at 15A. 24VDC at 7A. 5VDC at 8A. 15VDC at 1A. 15VDC at 1A. Input: 115V 60Hz 10A. 12"L x 5"W x 2.5"H. Modular construction, fan cooled. Weighs 4.7 lbs. P/N: 073-62624-101 with wiring diagram and test sheet. Learn More

Power supply. 12VDC 0.9Amp, switching. Output Adjustable 5% up or down. Input: 105-250VAC. Open frame. Dimensions: 35 x 97 x 79.5mm. Weight: 250 grams. NIB. with specification sheet. Connector. Learn More

0-5000V 0-5mA Regulated Adjustable 120v-iN Not-Metered Rack-mountable Learn More

Power Supply. Battery charger. Input 120VAC 8 watt. Output: 6VDC 400mA 2.4 watt. Complete with attached 6 foot cable. Wall mount. This is the style used to recharge a lot of weed-wacker and hedge trimmers. Learn More

5V@20A 2X 12-15V@1.75AMP SWITCHER P/S OPEN FRAME Learn More

POWER SUPPLY, 117VAC 5 W IN 6V /7.5V /9V DC ADPT 300MA OUT WITH CHANGEBLE POLARITY AND 5 WAY ADP. Learn More

Power supply. Battery charger. Switchable input 120/240VAC. Output: 1.45VDC 45mA. Wall mount. Cable with a 2.5mm plug. Listed: UL/CSA. Learn More