Other Process Control

8 Point Input 5VDC Sink Learn More

HOFFMAN – 404210 - FT015H-4 – Float and Thermostatic F&T STEAM TRAP, 15 psi, 406F, 5-1/2 In. L The Hoffman Specialty float and thermostatic (F&T) steam trap, model FT015H, features a 1" trap connection in a same side, H-pattern configuration. This pattern allows steam to enter from either side of the trap, and the condensate to discharge from either the opposite or the same side of the trap. This configuration also allows for more flexibility when piping in. H Series F&T traps are continuous drainage and are designed for low, medium, and high pressure steam mains and come standard with stainless steel internal parts. The FT015H is cast iron and has a 15 psi maximum operating pressure. This trap has a capacity for 1,600 pounds per hour. The traps are designed for service on heat exchange equipment where there is a need to vent air and non-condensable gases quickly. They are recommended for modulating pressures where widely varying loads are present and are a good choice for their ability to vent air at very low pressures, handle start up air loads, and operate against back pressure. Type: Series H Steam Trap, (F)NPT Connections 1 in Max. Operating PSI 15 PSI End to End Length 5 ½” Condensate Capacity Lbs/Hr: 1,600 lb/hr Max. Temp. 406 Degrees F Type Float And Thermostatic Body Material Cast Iron Pipe Configuration (4) Pipe (2) Inlet and (2) Outlet, Pressure Air Vent Self-Adjusting Application For all Process Applications Requiring Removal of Condensate, Includes Air Vent (F)NPT Connections: 1 in Max. Operating PSI: 15 psi Condensate Capacity Lbs/Hr: 1,600 lb/hr Max. Temp.: 406 Degrees F Body Material: Cast Iron Type: Float And Thermostatic Pipe Configuration: (4) Pipe, (2) Inlet and (2) Outlet Pressure Air Vent: Self-Adjusting Application: For all Process Applications Requiring Removal of Condensate Includes: Air Vent Manufacture: ITT Hoffman specialty. Proudly Made in USA Learn More

Conductive metal sensor. 10-30VDC 0.25A 18mm Dia, has two threaded nuts. 97mm long. Long unshielded 3-cond cable. "standard range" SOURCE OUTPUT NO - with instruction sheet - Other models available, too - see Prox Switch category Learn More

E Learn More

Programmable Controller. 16 channel analog voltage input module. 1 - 16 selectable, single ended. New. Learn More

General Electric - 44A399746-G01 - REG8C Power Supply Board.

Status: Discontinued

REG8 1050 BATTERY CHARGE

3N8100PS102A1

FAB# 44B399267-001

BD# 442B399855-002/7

CNC/ PLC Controller

Note: Commercial Fixed Repair cost is as high as $1568

Removed from Working Controller.

 

Learn More

General Electric - 3S7505PS700C6 - Reflex Photoelectric Relay with Optional Time Delay.

Status: Discontinued

Photoelectric Scanner

115V 50/60 Hz 12VA.

Output: 115VAC 1/10HP 5Amp Resistive.

DPDT Relay Output 

Genuine General Electric

New Old Stock

Learn More

General Electric - CR101H1 Switch, motor with NEMA 1 enclosure.

The CR101H manual motor starters provides dependable overload protection for single-phase motors up to one horsepower (115 or 230 Volts), and is the most economical starter choices where undervoltage protection is not required.

NEMA, Toggle, Starter Type Manual.

16 Amps AC, Max Voltage 277.

1 HP @ 1 Phase - 115V, 1 HP @ 1 Phase - 230V, 1 HP @ 115VDC, 1 HP @ 230VDC.

NEMA Type 1, No of Required Thermals 1, Number of Poles 2.

Height 4.16 In, Width 2.28 In, Depth 2.63 In

Standards UL (508)/ CSA.

Learn More

Process control. 8 Channel relay 12-30VDC or 12-250VAC output module. 4 Form C (SPDT). 4 Form A (SPST NO). Used/Removed from equipment. Learn More

Thermocouple temperature controller, 4 digit. 110/220VAC, SPDT relay output. ON/OFF. Dimensions: Only 3.5" wide x 1.66" x 5.86" deep. Note: Jenco Electronics LTD - P/N 372KC. Learn More

Transmitter power board. For controllers. Learn More

Relay output board. For controllers. Note: Attached - Omron - G6B-2114P-US, 5VDC Dip relay. Learn More

9-pin D sub Extension cable Learn More

Cable. US-100 4-Position female micro connector and LED(s). On Woodhead/Brad Harrison cable, AG10898 3X0.34 MM2/22 AWG 300V. jacket: Silicone. Alt P/N: U80370. Learn More

Cable for 3 wire and 2 wire Dc sensors. 4 Position micro connector on a single ended 3 Conductor 22AWG wire. 300V 105 Deg C. Brad harrison/Woodhead. Learn More

EAO SWITCH - 704.01-1892BX - Pushbutton Momentary Actuator for Series 4 Oil & Watertight switches.

Operation: SPST (On)

Voltage: 250V

Power: 2.4 Watt.

Mount: Single Hole 22.5mm (0.885") Diameter.

Terminals: Screws

Cap Color: Red.

Note: Body Marked 704.950.0

Protection: IP65

Approvals: UL, CSA

More info: http://www.eao.com/eus/en/products/condensedcatalogue/byseries//series_04.pdf

Made in Switzerland

Learn More

Bus extender board. Learn More

Dual ESD Mat Monitor, 24VAC. Control Unit LEDs indicate proper grounding of mat and two operators; includes. Allows mounting Control Unit at eye level, not using any work surface area; illuminated LEDs continuously display grounding status. May have been in use? Learn More

Daniel Woodhead Co. - 80350-001 - TEE Splitter, Female Micro Change Cord Interconnection Device

Daniel Woodhea Company a Brad Harrison Company - The leading industrial communications and connectivity brands, Brad Harrison, mPm, and SST, are now united with a single vision – to be the preferred global resource for industrial automation, communications and connectivity.

22 AWG, 4 Conductor 40 S-R PVC

Voltage: 250V AC/DC

Amerage: 4A

Operating Temperature: -4 to 221 F

Length: 1 Meter

Female Type: Die Cast Black Epoxy Coated Zinc Coupling Nut

Molded PVC Body

Nitrile Rubber O-ring

Nylon 6/6 Connector Face Material

Yellow Color

Additional Information: https://www.cesco.com/resources/Molex-Woodhead-Connector/1200700253/Catalog.pdf

Factory New - UL / CSA Approved

Proudly Made in USA

 

Learn More

DANIEL WOODHEAD CO - 40978 - Process Control.

Daniel Woodhead Company a Brad Harrison Company - The leading industrial communications and connectivity brands, Brad Harrison, mPm, and SST, are now united with a single vision – to be the preferred global resource for industrial automation, communications and connectivity.

Cordset 3Position Female molded mini-change connector

16AWG, 3Conductor

Voltage: 600V

Current: 10Amp.

Operating Temperature: 105 Deg C.

Length: 9 Foot.

Molded PVC Body

Yellow Color

Factory New - UL / CSA Approved

Proudly Made in USA

 

Learn More

Filter, water. For cold water service, sediment removal. Learn More

Hardware. Vari-Depth rotary handle, mechanism. Nema 1, Nema 3A, Nema 12. With hardware. Application: Typically used on enclosed circuit breakers, control panels and motor control centers. Note: NIB. UPC 786679-02700. Style 504C323G07. Learn More

CUTLER-HAMMER - 47A4446G36 - Hardware.

Shaft assembly for Molded Case Circuit Breaker Accessory Handle Mechanism.

Amperage Rating: 30-60-100-200 Amp switches.

Series: Series C

Shaft Length: 6.5 in

UPC 786679-65180.

Style 47A4446G36.

Learn More

D100CRA20 I/O PLC, 13 AC-Inputs/8 Relay Contact Outputs, 1440VA per Output Contact. No memory cartridge in location. Dimensions: 9.5 x 5 x 4.5"H. Weight: 3 lbs. Learn More