Special Relay

10-pole Double-throw Western Electric telephone relays. Two 1300-ohm coils, one for each set of 5 precious metal bifurcated contacts. Absolutely beautiful construction, W.E. did such nice work in the 50's and '60's . . . may be a small bit of rust that would not effect operation. Learn More

Relay, special. Contacts: 1A. Coil: 33.4VDC 2000 Ohm. Connection: 8 solder hooks. Electrical conf: DPDT. Mech: 4 mounting tabs. Body: 19.6mm long including 8 solder hooks, 10mm wide and 5.5mm. Weight: 0.1 oz. Hermetically sealed MicroMechanical. Bourns. Learn More

48vdc 48PDT Magnetic latching -TwoCoil 115-Ohms Enclosed Precious metal contacts - NEW Pulse to latch, pulse in opposite polarity to unlatch. Learn More

48VDC 36PDT Magnetic latching relays. Enclosed Precious metal contacts - New Pulse to latch, pulse in opposite polarity to unlatch. Learn More

Relay, SSR. Control: 3-8VDC (10VDC max) (Input 8Amp max). Load: 20Amp 90-280VAC 400Hz (output 0.1Amp min). Case. Encapsulated module. Dimensions: 2.003" sqaure x 1.224" high. Contacts: screw. Note: solid state. New older stock. Learn More

Single or Two point differential sensing device housed in a 48 x 48 DIN case with 11-pin Octal-type plug. Operating Resistance adjustable from 2Kohm-ON / 5K-OFF, to 20K-ON / 50K-OFF Variable Sensitivity Level Controller for Conductive Liquids - Dual voltage sensing relay Supply Voltage: 110V or 240VAC a.c. (+10% 50/60 Hz) Power Consumption 4VA OUTPUT: SPDT-5Amp relay contacts. Operating Temp: -100C to +600C Boxed and Unused with spec's. Learn More

RBM CONTROLS - 91252-1667 Relay, control, motor start.

Contacts: SPST.

Contact Ratings: 3Amp.

Coil Voltage: 115VAC (1/12HP motor start at 60 Cycle).

Connections: screw (3). Mech Mtg: Panel.

Note: This relay is specifically intended to connect a starting capacitor to a split phase motor starting winding until the current drawn by the run winding drops below the current threshold of a typical 1/12 HP AC motor (120 VAC). As the motor approaches operating speed, the current drawn by the run winding drops less than an amp. Bulk.

Learn More

Relay, flash transfer. Input: 120VAC. Contacts: DPDT. Contact Ratings: 30A. Connections: Cinch-Jones plug on bottom. Packaging: transparent plastic case. Size: 2.84"L x 1.75" x 2.25". Note: 21 series. Socket available P/N 8-715. Learn More

ELECTRONIC CORPORATION AMERICA, ECA - NO. 8-591 

Solid State Low Leakage Relay 0-30MA,

0-120V, AC OR DC 

Note: For Use with Type 42MTB Photoswitch Terminal Bases

NSN: 5945-01-232-5447

Alternate: CA0509-005

New Old Stock

Proudly Made in USA

Learn More

ALLEN BRADLEY - AB - 809S-BB100A1-A AC Current Relay.

Status: Discontinued

Solid State Undercurrent

Trip Current Range Adjustable from 1.0 to 12 AC Amperes.

Supply and Inhibit Voltage: 120V 60Hz.

Maximum continuous current 18Amps AC.

Automatic Reset, Adjustable Differential, Adj Trip Current, Adj Time Delay from s/d pots on top of device.

Use Directly or with Current Transformer. 2 lbs.

Learn More

Postage Stamp - plug-in relay 1,840-ohm coil DPDT-2A23.4-37VDC Hermetically sealed 28VDC Learn More

Relay, control, DC. Contacts: SPDT. Contact Ratings: 1VDC, Pulls in about 0.2VDC. Coil Resistance: 3.5 Ohm. Packaging: Hermetically sealed. Size: 1.5" x 1.5" x 3" tall. Note: PAT#2425092. Learn More

Pulled from socket of exotic electronic test equipment. 16-pins and one threaded stud. 29.3mm x 18.2mm x 36.2mm tall. Solder terminals or plug into 16-pin socket. Single 700-Ohm coil. Sealed silver can. Learn More

AUTOMATIC ELECTRIC - 280R66K -  Relay, Telephone.

Special Purpose, Very Sensitive.

Enclosed. 4-7/8" Long x 1-11/16" Wide x 1-1/2" high.

Note: Inside Marked 280 R, 66K.

Vintage Automatic Electric - New Old Stock

Learn More

Relay. Case: shielded 8 octal. New, older stock. USA. Note: Danger - High Pressure - Do Not Open. Learn More

WILKERSON INSTRUMENT CO - MM4300 - Transmitter, Mighty Module Transmitter.

The MM4300 provides a DC output, fully isolated from input, line power and ground, proportional to a DC input. It is useful in eliminating ground loops and common mode signals.

DC Isolated

0-10VDC input to 4-20mA Output.

AC Supply: 115VAC, Pug-in Octal (8) pins.

Plastic Enclosure.

Learn More

Western Electric - 316M - Relay, Telephone/Teletype.

Package: can 1.7" square x 3.9" high, including 11 contacts and handle.

Note: Marked "Under High Pressure - Do Not Open".

Boxes are marked 100993799 316M 6-74 571.

Genuine Vintage Western Electric - New older stock.

Learn More

UNI9-7 - Universal Starter Starter Solenoid Relay Assembly, 3-Terminal.

Coil Voltage: 12VDC

SPST Normally Open Contact

Coil Resistance: 4 ohms,

Coil Current: 3 Amps, Momentary Duty.

Two Large Copper Contactor Terminals: 5/16-24,

Single Coil Terminal: 10/32

Grounded Case/Base.

Heavy Duty 

One side of coil internally connected to integral mounting bracket, very high resemblance to those used in Ford Automobiles, Trucks, Tractors, and/or Marine. Replacement Solenoid for Oliver Tractors, Indust/Construction, International Harvester, & Allis Chamers applications.

Learn More

TURCK - MS25-10 - Multisafe Rotational Speed Monitor 115VAC.

OUTPUT PULSE 4--20mA 0-10VDC

Status: Discontinued

Dimensions: 5" x 3" x 2.25"

Made in Germany

Used / Removed from Equipment.

Learn More

KUHNKE - 130-2-01-2-10 - Timing Relay, 11 pin Plug-In relay.

Kuhnke manufactured relays since 1948; during 2004 the relay division was sold. The range was extensive; Kuhnke relays can still be found in medical, railway, power generating applications as well as industries such as printing, textiles and machine automation.

Kuhnke Series 130 Timing Relay

Type: Pull-in Delay.

Adjustable "0-10" or 0.2 to 10 Seconds.

Red LED Indicator.

New. - Kuhnke Austria

 

Learn More

E. Dold & Sohne KG - AI937 - Relay, Time.

Contact Ratings: 3Amp.

Mech Mtg: Din Rail.

Note: Input: 110VAC 50/60Hz.

Adjustable frequency 45-110Hz.

Contact Rating:

• 24 VAC, 3 A , 2.5 A
• 110 VAC, 3 A , 2.5 A
• 220 VAC, 3 A , 2.5 A

Dimensions: 45 X 127 X 77mm
Weight: 0.3 Kg

Factory New

Learn More

EATON - CUTLER-HAMMER - D50ER14 Expander 14 I/O 24VDC relay.

The Cutler Hammer D50 Series PLC Programmable Logic Control can be used for many different applications. The D50 PLC can also be a standalone controller that contains a Central Processing Unit (CPU) power supply, and input/output circuitry with terminals. No battery backup is needed for the 2K memory controller, and there is plenty of programming capacity for complex control schemes. The large number of timers/ counters relays, and data registers allow you to maintain the smallest PLC size PLC possible when you must upgrade to larger more expensive systems.

Status: Discontinued

Programmable Logic Controller (PLC)

D50 Series Module 14 I/O EXP Relay Output

I/O Module, 14 Point, 24 VDC

UPC:  78211400072

Alternates: D50ERI4, D50ERL4, D5OER14, D5OERI4, D5OERL4, DS0ER14, DS0ERI4, DS0ERL4, DSOER14, DSOERI4, DSOERL4 

New

Learn More

Switch, stepper. 24VDC coil draws 1Amp. 5-Pole 10-or-11 Positions, 4 decks are non-shorting and 1 deck is shorting. Provided with auxiliary self-interrupting and homing contacts. New in old box. 110x50x67mm. Made in US like a Swiss watch. Learn More

HI G - M39016/18-30L - MGAPD-26 A or B - Micro Miniature Relay

Contact Material: Gold, Metal

Mount: Through Hole

Coil Current: 16.99 mA

Coil Resistance: 1.56 kΩ (1560 Ohm)

Coil Voltage (DC): 26.5 V

Operating Temperature: -65 C to 125 °C

Max Voltage Rating (AC): 115 V

Max Voltage Rating (DC): 28 V

Throw Configuration: DPDT

RoHS: Compliant

Alternate: MGAPD -26 A or B

CECC Designation: 16207-801-GBA 1Y-E3. 16207-801-GBA 1Y-rE5 

Learn More