Light Sensor

EATON CUTLER-HAMMER - E51KT443W - Photoelectric Sensor SW. Series A1.

Genuine Cutler Hammer

Fiber Optic Proximity Switch

Overall Length Approximately 36 Inches

New 

 

Learn More

Light wand phototransistor in a pen assembly. Bar code reader. (Universal = will work for anything it was meant for). Cord is approximately 15 feet long. Note: 23pcs have a DE9 male & 11 have a circular connectors. Learn More

Clairex - CLM5H10A Opto-Isolator,  17mA, 10V, Photo Mod Low Current Module,  New Photo Resistor Photo Cell/Lamp module 3K Ohm - "ON" Resistance, 10 meg. Ohm "Off" Resistance, 10V Dimensions - .415" Diameter by 1.125" Legnth, Cell Volts PAC - 100, Isolation Voltage PAC - 2500.

Obsolete Factory new Manuf spec's: www.datasheetarchive.com

Learn More

Photo-resistive cell. No other information available. Learn More

Cover for OTBVN6QD Opto-Touch Switch, plastic guard, housing only. Learn More

Photoelectric sensor. Fiber optic microswitch. LO/DO NPN 20mm range. Red: DC10-28V. White: output. Green: LO/DO. Black: OV. Learn More

Sensor, light. Receiver probe. On Belden 8451 22-2C foil shielded cable, solid. Length: 5 foot. More info: http://www.autodev.com/assets/downloads/sensors-controllers/ig01.01---8800-instructions_2008.pdf Learn More

Banner Engineering Corp - RSBFV - Visible Red 650nm fiber optic Sensor Head

Designed for use with GLASS fiber optics, Not plastic

Light Source: Infrared

Sensing Method: Diffused

Range to 10" [see excess gain charts]

Response to 1mS in HS mode only

RSBFV will Not operate with 2-wire power blocks

LIGHT/DARK Operate

Programming ring with four notches.

Dimensions: Height 48mm, Length 114mm

Alternate: Mouser 778-RSBFV

New

Learn More

WattStopper - HB350W-L3 - High Bay Passive Infrared Occupancy Motion Sensor for Wet Locations

The HB350W-L3 High Bay Passive Infrared (PIR) Occupancy Sensors for Wet Locations consist of a sensor and a lens
module. Designed for automatic lighting control in warehouses and other medium and high bay wet location applications.

The HB350W-L3 occupancy sensors are designed to mount to a light fixture and control one load in that fixture. They can be wired to control all ballasts in the fixture, or to control half of the ballasts, providing high/low lighting control. When motion is detected within the sensor’s coverage area, the relay in the sensor closes, and lighting loads are automatically turned on. When motion is no longer detected for the duration of the time delay setting, the relay opens and the lighting load is turned off. The sensor’s sensitivity and time delay settings are factory preset at “normal” and 15 minutes, respectively, which are suitable for high
bay applications. However, if the values need to be adjusted for specific applications, they can be easily changed using the DIP switches on the unit.

Weight: 6 Ounces

UPC: 754182924042

Additional Information: 

https://www.mc-mc.com/ASSETS/DOCUMENTS/ITEMS/EN/WattStopper_HB350W_L3_Installation_Instructions.pdf

https://assets.usesi.com/product-media/brochures/500654_brochure.pdf

New

 

Learn More

Photoelectric scanner with shielded cable. Dimensions: rectangular 0.886" wide x 0.376" deep x 0.636" high, overall with threaded body 1.905". No other information available. Learn More

Silicon Detector - SD-076-12-12-011 - Photodiode. Blue-Optimized, TO-46-2 Gold Leads, New. A photodiode is a semiconductor diode sensitive to photon radiation, such as visible light, infrared or ultraviolet radiation, X-rays and gamma Rays. It produces an electrical current when it absorbs photons. This can be used for detection and measurement applications, or for the generation of electrical power in solar cells. Photodiodes are used in a wide range of applications throughout the electromagnetic spectrum from visible light photocells to gamma ray spectrometers. Silicon photodiodes are semiconductor devices used for the detection of light from the ultra-violet to the near-IR regions (200nm – 1100nm). OSI Optoelectronics has developed a wide variety of photodiodes which are suitable for many applications such as: Position Sensing, Power Monitoring, X-Ray & Gamma Detection. Photodiode. Blue-Optimized. Photosensitive Area: 2.9mm. Spectral Response Low: 290nm. Spectral Response High: 1.1um. Package: TO-46-2 Metal Can Gold Leads, Hermetically Sealed. Factory new. Note: Silicon. Learn More

Silicon Detector - SD-076-11-11-011 - IR Photodiode. Infrared. TO-46-2 Gold Leads IR Photodiode – Low Noise – High Shunt Resistance – High Response. Photosensitive area: 2.9mm. Spectral response low: 300nm. Spectral response high: 1.1um. Active Area: 2.7 x 1.1 mm Temperature: -40 C to 125 C Package: TO-46-2 Gold Leads Hermetically Sealed. Factory New - Rare. Note: Infrared. Applications: Instrumentation, Industrial, Medical, Analytical Equipment Learn More

230VAC-Input "complete" PhotoElectric Control / Amplifier with Power Supply - Diode Protected NPN Open Collector Output - 15-turn sensitivity adj - red LED output indicator - may be wired for LIGHT or DARK energize - provides light source power and amplifies the photodetrector signal, use either a reflective skanner or thrubeam pair. Learn More

Relay 230VAC. Led indicating. Case: Plastic enclosed 11 octal plug in mount. Learn More

Relay 24VAC. Led indicating. Case: Plastic enclosed 11 octal plug in mount. Learn More

Clarostat Honeywell SKAN-A-MATIC - T31101 - Photoelectric Amplifier

Features:
■ Open collector output
■ Plug-in 8 Pin Plug
■ Output indicator LED
■ 15 turn sensitivity adjustment
■ May be wired LIGHT or DARK energize
■ 5 VDC Input

5VDC Sensor Amplifiers Photoelectric Amplifiers Open Collector Output capable of loads up to 250ma. @ 28vdc maxPlug in mount LED Output Indicator

New Old Stock

Made in USA

Learn More

Photodiode. 1000nm. High speed. High sensitivity. Built-in visible light cut off filter. Specification sheet upon request. Learn More

Philips - NXP - RPW100 Sensor, Pyroelectric Detector, Photoconductive Infrared.

Dual-Element Motion Detector with 6.5 -14 µm Bandpass.

One Channel. 

Photosensitive Area 2.0= (mm2).

Spectral Response Low: 6.5u=(m).

Spectral Response High: 14u=(m).

Re Min.(V/W) Responsivity=23.pyroelectric 

Element Operating Temperature: 22.

Package: TO-39 var. Gold Base and Leads

Made in United Kingdom

Note: Amperex P/N: 4-53044-2.

Learn More

Photodiode. Bi-cell. Active area: 3.23mm, per element. Blue enhanced photoconductive. Flat window. VBR 100V. Light current: 0.5mA. Case: TO-5 gold hermetically sealed, long leads. New. Note: Silicon. Marked DT PIN-SPOT/2D. Photonic Detectors. Learn More

OMRON - EE-SB5 - Sensor, Reflective. 

Sensing Distance: 5mm.

Output: Phototransistor.

Package: 4 Pin housed with mount tabs.

Application: Designed to effectively reduce influence of external light interference.

Contacts: Solder Terminals.

Note: Lead free.

Rohs Compliant.

Learn More

50 SERIES DIFFUSE REFLECTIVE FAR RANGE PROXIMITY DETECTOR 10-30VDC 4-Pin Male Plug Learn More

EATON CUTLER HAMMER OPCON - 1170A-300 - Led Source with Lens #101106

LED LIGHT SOURCE with Convex Lens which provides a broad radiation pattern - small effective beam pattern and short operating distance 0.15"

P/N 101106 -

With long two conductor cable (HEAD DIMENSIONS: 1.26"L x 0.31"DIA. ) With/ 9FT. CABLE

UPC 782113819709

Manufactured in Washington USA

Learn More

Fixed focal photoelectric switch. Diffuse Scanner 10-60mm range. Self contained, IR modulated LED(Range determined by using 90% reflective white bond Kodak paper). Learn More

PHOTO ELECTRIC SWITCH THRU BEAM UP TO 100' (SINKING NPN) 10-30V 100MA MAX

Learn More