Miscellaneous

CLAROSTAT - VR-003 - Rheostat. 2 Ohm. Vintage Radio Tube Filament Control, New Old Stock.

Used in series with tube filaments to adjust current. Extends the "useful" life of RF tubes to keep the emission of the tube above the recommended minimum for the maximum amount of time.

Resistance: 2 Ohm.

Technology: Wirewound.

Mount: Panel.

Threaded Bushing: 3/8" D x 11.3mm long,

Shaft: 1/4" D x 2.5mm high. Screw Driver Adjustable.

Contacts: 2 Solder Hooks.

Marked 140-660, X-4094-C.

Alternates/Similar: Carter Radio Co. / Central Radio Laboratories Pot Control Wire Wound Rheostats

Genuine Vintage Clarostat - New Old Stock 

Made in USA

Learn More

Crystal. 6.1440MHz, quartz parallel resonant. Package: HC-18. Learn More

CTS Electronic Components - 864296-1 - 1378507 Panel Mound Potentiometer.

Resistance: 90 Ohm.

Power: Approximately 3/4 watt.

Mount: Panel or PCB

Contacts: PCB Terminals.

Dimensions: 16.3mm Diameter x 9.4mm High.

Note: Brass Threaded Bushing Length: 1/4".

Shaft: 3.9mm Diameter, 0.375" Long Plastic "D" Shaft.

Anti-Rotation & Brass Hardware 

Silver Terminal Tarnish does not affect operation.

Genuine Vintage CTS - New Old Stock

Applications: Music/Audio/Guitar

 

Learn More

BOURNS - TF200G - Bourns 6-Pot & Knob Assembly

Nice Assembly with Six (6) potentiometers with knobs and six (6) 1K trimpots.

Three 10K and Three 2.5K Bourns 3859A- 3/4" Diameter Cermet Single Turn Potentiometers

Quality Black & Silver Indicating Knobs.

Black Aluminum Assembly measuring 3.75" x 3.8" x 1.4", 3006P-103 care 3/4 Watt 15-turn trimpots.

Chromascan colorimeter adjust board.

Note: Bourns 3006P-103 Trim pot retail $15 Each.

 

Learn More

ISKRA FERITI - FP15G100 51-00 - Ferrite Rod. Perfect for Amateur and Crystal Radio.

The Iskra Feriti (Iskra Ferrites) company has more than 40 years’ experience in the production of ferrite materials and products.

Ferrite Rods, Bars, Plates and Tubes. Ferrite rods, bars, slugs, plates and tubes are primarily used as magnetic cores in radio antennas, chokes, inductors and filters. In radio antennas, ferrite rods are useful from VLF spectrum to VHF spectrum. The advantages are small size, high Q and compactness. They are used for their properties of high magnetic permeability coupled with low electrical conductivity (which helps prevent eddy currents).

Ferrite Rod Core is a cylindrical ferrite core, can be easily assembly with a spring coil or wind wire directly. It's widely used for radio antenna, LF/HF RFID antenna, choke coil, inductor, DC power filter, DC signal filter and transformer. Due to the open magnetic structure, the core can accept large DC bias before saturate. The rods are design to use for MW and shortwave antenna coils; in high frequency applications they have low loss characteristics.

Large ferrite rod made for radio "Loopsticks"

Authentic Vintage Iskra Ferite - New Old Stock

Dimensions: 10mm D x 50.8mm long. (0.394" X 1.969")

Additional Information: http://www.holmmagnetics.dk/html/kurver.html

Learn More

ElectroCraft - EL CAP - 8011 0078 - CAP1684 - Dual Section, 1000uF & 250uF @50 VDC, Type FP DUAL 1000uF @ 50VDC & 250uF @ 50VDC in the old style FP or WP can with 4-mounting lugs and 3 cap lugs, common negative. Type: Type FP-WP Metal Can Electrolytic Capacitors Temperature: 85 C Large Can Twist Prong Mounting Lugs Metal Can Audio Capacitor - Dry Electrolytic as used in Vintage TV's and Radio. >25 years old so should be reformed before use. Reforming is accomplished by bringing up to rated voltage with current limited Power Supply. Dimensions: 1.38" Diameter x 3" Length with lugs. Plastic Insulated. Applications: Restoration of Vintage Audio. "El Cap" capacitors, typically refers to Electrolytic Capacitor, commonly manufactured by companies like Nichicon, KEMET, Panasonic, Rubycon, ElectroCraft, Elna, and Jianghai; with "El Cap" being a shortened way of saying "Electrolytic Capacitor" - so essentially, any company producing electrolytic capacitors can be considered a "maker of El Cap capacitors.". New Old Stock – Rare – Difficult to Find New Made in USA Learn More

Battery accessories. Holder for two 1/2 AA. Material: Plastic. Wire leads. New.

Learn More

Tube, electron. Base: 8 pin octal, with only 6 pins in use. Learn More

DUPONT - TUT10BG3 - Tedlar. Polyvinyl Fluoride Film (PVF).

DuPont™ Tedlar® protective film helps extend the look and life of your design, even in the most extreme environments. From severe weather to harsh chemicals, Tedlar® protective film provides long-term durability and performance. Tedlar® protective film can easily be applied to a range of surfaces, providing the flexibility to design your way, and the surface performance to keep it that way.

Features: Long Term Protection, Fatigue Resistant, Good Elongation, Good Printability, Good Color Stability, Photolytic Degradation Resistant, Low Toxicity, Good Processability, Alkali Resistant, Excellent Long Term Heat Aging Properties, Crack Resistant, Solvent Resistant, Good Abrasion Resistance, Excellent Dielectric Properties, Acid Resistant, Excellent Formability, Cleanable, Durable, Glossy Surface Aspects, Bacteria Resistant, Heat Sealable, Low VOC, Excellent UV Stability, Flexible, High Dielectric Strength, Flame Resistant, Good Surface Finish, Corrosion Resistant, Good Weather Stability, Mildew Resistant, Excellent Salt Spray Resistance, High Temperature Resistance, High Gas Permeability, Sound Transmitting, Microbe Resistant, Chemical Resistant, Good Stain Resistance

UV Screening Transparent Film.

Roll Length: 4900 Feet x 1" (25.4mm) Thick.

Applications: Major uses of Tedlar are backing materials for photovoltaic panels, with a life expectancy of over 20 years. Another major market for clear Tedlar films is on thermoformed panels used on the inside of commercial aircraft. The Tedlar film provides graffiti resistance and makes the surfaces very easy to clean.

New Old Stock - Highly Discounted

Learn More

AMPERITE - 115C3 - Electron Tube, Relay, Timer. 3 Sec 3Amp 115VAC.

Input: AC.

Contact Ratings: 3Amp.

Coil Voltage: 115VAC.

Connections: 4 Pin octal plug-in.

Timing Function: 3 Seconds.

Learn More

Cornell Dublilier - 410-56 - Capacitor, Mica. 800pF, 30,000V,  22A @ 1MHz.

800pF (.0008mfd)

Type PL 410-56

Enclosed Broadcast Transmitting Capacitor.

Note: High Voltage, 30KV (30,000Volts).

Approximate Overall Dimensions: H 10.0" X W 7" X  D 7"

Cylinder Diameter: 6"148

Mount: Panel Four 3/8" Bolt Mount 6.750" Square Mount Top & Bottom.

Wight: Approximately 28 lbs.

Note: Items over 5lbs required extra shipping costs depending upon destination.

Broadcaste Station Spare - Appear to be "New Old Stock"

New Old Stock - Proudly Made in USA

 

Learn More

Crystal. 12MHz. Quartz crystal resonator. Case: SMD HC49B, 4.4mm high. More info: Interquip Electronics Co Ltd. http://www.interquip.com/asset/productPDF/143/5313cf3800364.pdf

Learn More

Crystal. 4.00MHz. Case: HC49 SMD. New. Note: More info http://www.transko.com/img/product/crystal_pdf/hc49smd4.pdf Learn More

Quad 4-Position Thumb or Screw Driver Binding Post, Phenolic Terminal Strip Board.

These heavy-duty binding posts were designed with the audiophile in mind. The high-quality plating process eliminates the possibility of corrosion to maintain the highest possible signal transfer and resist harsh environmental conditions.

Key Features

• Satin nickel
• Audiophile quality
• Ideal for high power applications
• Non-oxidizing

Phenolic Strip  0.065" Thick

Contact Material: Brass Nickel Plated Screw Terminals

The large 0.25" diameter knurled head allows for positive finger tight connections. Length 0.50"

Contacts: 4 Position Quick Connect or Solder Terminal Lugs on back of unit.

Terminal Strip Dimensions: 2.875" Long X 0.64" High, Protrudes 0.56" in Back

Secure Electrical Connection for Optimum Performance.

Applications: Speaker sets, Shortwave Radio, Antenna Connections, Audio/Visual, TV, Two Radio, Drake 2a, Etc..

Vintage New Old Stock

Proudly Made in USA

Learn More

WOLVERINE - TAAPA0001 - Page Adapter+

Telephone Product

With HSAACC002 Power Adapter - 120VAC Input/12VAC 1A Output

Proudly Made in USA 

Learn More

Tube, electron. Base: heavy 4 Pin. Made in the USA. More info: http://www.westernelectric.com/spec_sheets/313ca.pdf Learn More

AA Battery Holder.

Holds 4 AA batteries in a 2-by-2 pattern.

Series-connected for 6 volt output.

Dimensions 2-1/4" x 1" x 1-1/8".

Includes a mating snap-on connector, to which leads may be soldered.

Learn More

Unidentified MFG - 244D-01-4401 - Board. Circuit Board.

With socketed IC's. One Motorola MC68B09CP, 2 pieces MC74HC123AN. One MC74HC00AN, One MC74HC273AN and one ZMD U630H04BD1C.

All assembeled with 40 wire-wrap pins on the back of the MC68B09.

New

Learn More

Module. RF, power. Mount: PCB or Panel, 2 hole with 2.3" centers. Dimensions: 2.085" long x 0.842" deep x 0.311" high on a bracket. Overall 2.651" long x 0.842" deep x 0.331" high. Contacts: 6 very fragile RA PC leads. Learn More

Battery, lithium. 3.6V, 1/2AA. High energy. Learn More

Television camera. No tubes or lens. New, with manual. Learn More

Sylvania - 9002 Tube, Electron.

6.3V 0.15Amp.

Base: B7G, 7 Pin.

New in Box.

NSN: 5960-00-116-9986

Made in USA

Note: Maybe replaced with equal manufactured by RCA.

Learn More

Crystal. 15.360MHz. Tuneable/Adjustable. Mount: PCB. Package: metal housing, 3 Pin. Dimensions: 0.725" long x 0.473" wide x 0.195" high. New. Note: Manufacture: Spectrum. Learn More

Boards. MAX 5000 device, high-speed, high-density IC EPM5128LC-1. Picker Scientific 0620183-01 Rev 2, PC assembly logic board. Made in the USA. Learn More