Sensors

Transducer, linear motion. Pos. Sens: 39.488 mV/V/Inch Vel. Sens: N/A (mV/100 IPM). Two foot steel tether/cable. Dimensions: 3" x 4" plus base. Contact: Male 6 pin MS connector. No indicator or controller. Used/Removed from equipment. Learn More

Sylvania  GTE - SB605G1H - Switch, Bimetallic Thermal Switch.

Sylvania GTE Thermo-Protectors are designed to provide the ultimate in low cost protection for the electrical equipment industry. The units are small, lightweight and are easily adaptable to any application.

Status: Discontinued

Benefits
• Hermetically sealed
• Compact
• Opening temperature range of 100 ºC to 170ºC in 5ºC increments
• Snap action
• Tin plated copper leads in a variety of lengths
• Safe from penetration of fluids
• Ultimate corrosion protection
• No secondary insulation needed
• Can operate in high pressure environments

100 C No current Opening Thermal cut-out

Resettable Switch / Self-Resetting

Package: Glass Envelope 0.285" D x 1.281" long with Radial Leads.

Often referred to "Clicker Fuse"

Vintage Sylvania - New Old Stock - Rare

Learn More

TELEMECANIQUE - XUE-H307534 - Photoelectric Sensor Receiver.

Status: Discontinued

Photoelectric Receiver

Through Beam: 30m

Voltage: 12 - 48v with protection against reverse.

Switching Capacity: </= 200mA with Overload and Short Circuit Protection.

Protection: IP 67

Operating Temperature: -25 C to 70 C

Connections: Screw Terminals

Max. Switch Frequency: 30 Hz

Note: Used / Removed from Equipment. 

Approvals: CE, CSA, UL

XUE-H307534 is replaced by XUXOAKSAM12

Learn More

Photoelectric scanner with shielded cable. Dimensions: rectangular 0.886" wide x 0.376" deep x 0.636" high, overall with threaded body 1.905". No other information available. Learn More

Silicon Detector - SD-076-12-12-011 - Photodiode. Blue-Optimized, TO-46-2 Gold Leads, New. A photodiode is a semiconductor diode sensitive to photon radiation, such as visible light, infrared or ultraviolet radiation, X-rays and gamma Rays. It produces an electrical current when it absorbs photons. This can be used for detection and measurement applications, or for the generation of electrical power in solar cells. Photodiodes are used in a wide range of applications throughout the electromagnetic spectrum from visible light photocells to gamma ray spectrometers. Silicon photodiodes are semiconductor devices used for the detection of light from the ultra-violet to the near-IR regions (200nm – 1100nm). OSI Optoelectronics has developed a wide variety of photodiodes which are suitable for many applications such as: Position Sensing, Power Monitoring, X-Ray & Gamma Detection. Photodiode. Blue-Optimized. Photosensitive Area: 2.9mm. Spectral Response Low: 290nm. Spectral Response High: 1.1um. Package: TO-46-2 Metal Can Gold Leads, Hermetically Sealed. Factory new. Note: Silicon. Learn More

Silicon Detector - SD-076-11-11-011 - IR Photodiode. Infrared. TO-46-2 Gold Leads IR Photodiode – Low Noise – High Shunt Resistance – High Response. Photosensitive area: 2.9mm. Spectral response low: 300nm. Spectral response high: 1.1um. Active Area: 2.7 x 1.1 mm Temperature: -40 C to 125 C Package: TO-46-2 Gold Leads Hermetically Sealed. Factory New - Rare. Note: Infrared. Applications: Instrumentation, Industrial, Medical, Analytical Equipment Learn More

230VAC-Input "complete" PhotoElectric Control / Amplifier with Power Supply - Diode Protected NPN Open Collector Output - 15-turn sensitivity adj - red LED output indicator - may be wired for LIGHT or DARK energize - provides light source power and amplifies the photodetrector signal, use either a reflective skanner or thrubeam pair. Learn More

Relay 230VAC. Led indicating. Case: Plastic enclosed 11 octal plug in mount. Learn More

Relay 24VAC. Led indicating. Case: Plastic enclosed 11 octal plug in mount. Learn More

Clarostat Honeywell SKAN-A-MATIC - T31101 - Photoelectric Amplifier

Features:
■ Open collector output
■ Plug-in 8 Pin Plug
■ Output indicator LED
■ 15 turn sensitivity adjustment
■ May be wired LIGHT or DARK energize
■ 5 VDC Input

5VDC Sensor Amplifiers Photoelectric Amplifiers Open Collector Output capable of loads up to 250ma. @ 28vdc maxPlug in mount LED Output Indicator

New Old Stock

Made in USA

Learn More

Shaft Angle Encoder 4.7mm round shaft ~ 27mm diameter, has long cable with MS connector. Learn More

Sensor, proximity. Inductive. DC 10..30V, 300mA. Double marked 7900035. Learn More

SICK OPTIC ELECTRONIC - IM12-02BNS-ZC1 - Sensor, Proximity. Inductive, DC 10-30V 200mA. 4-Pin, M12 Male Connector Sensing Distance: 2mm 200Hz Switching Shielded, NPN, NO. Double marked 6011972. M12, 4 Pin male micro connector. Learn More

Sensor, proximity. Inductive. NPN, DC 10..30V, 200mA. Sensing distance: 1.5mm. Double marked 6020176. Connector: M8 x 1mm. Learn More

Sensor, proximity. Inductive DC 10-30V 200mA. 3 Wire. 1.5mm shielded, NPN, NC. Learn More

Sensor, proximity. Inductive. PNP NC, DC 10..30V, 300mA. Sensing range: 2mm. Housing: metal. Double marked 7900007. Connector M8 x 1mm. Learn More

Photodiode. 1000nm. High speed. High sensitivity. Built-in visible light cut off filter. Specification sheet upon request. Learn More

RED LION CONTROLS - LMPC0000 - Sensor, Proximity.

LOGIC MAGNETIC PICKUPS (LMP’s) provide sensing sensitivitiesseveral orders of magnitude greater than standard magnetic pickups when detecting moving ferrous targets. By locating a high gain pre-amplifier & signal processing circuit “inside” the mag pickup housing, larger airgaps and slower target surface speeds can be achieved thereby greatly expanding application versatility as compared with conventional mag pickups. In addition, these units have excellent noise immunity and a frequency response to 10 KHz. The stainless steel sensing pole is mounted flush to the plastic sensing face allowing greater ease of setting airgaps and eliminating snagging the pole with a moving target.

NPN open collector output.

Body Style Cylindrical

Diameter 3/4 in

Function Speed

Length 4 in

Mounting Type Flush

Operating Temperature -18 to +60 °C

Output NPN

Supply Voltage 17 VDC

Switching Current 40 mA

Switching Voltage 30 VDC

Technology Hall Effect

Termination 3-Wire Cable

Wire Size: 22 AWG

Super sensitive magnetic pickup with current sinking output.

With attached 3 conductor shielded cable.

Note: Removed from New Equipment

Learn More

RED LION CONTROLS - PSAC0000 - Sensor, Proximity.

The Red Lion PSAC0000 is a 3 wire inductive proximity sensor with an operating voltage of 10-30V DC, NPN O.C. output, and a 1.5 mm sensing distance. It has a 304 stainless steel body with a 10 foot shielded cable. Inductive sensors are used with metal targets, as opposed to plastic targets. Works with most Red Lion monitors, counters, and controls.

Features

• Can sense iron metal or non-iron metal to 'zero speed'
• Has 0 to 5 KHz pulse output rate
• Case is epoxy coated to withstand dirt and moisture
• Can be used on targets as small as 12 DP gear teeth
• Perfect for tachometer, counter, and control input

Specifications

• Case Dimensions- 3.5" Length x 0.75" Diameter
• Sensor Diameter- 0.25"
• Overall Dimensions- 4.5" Length x 0.9" Diameter
• Operating Temperature- -25 C to 70 C (-4 F to 158 F)
• Supply Voltage- 10-30V DC @ 20 mA (not reverse polarity protected)
• Max. Switching Frequency- 5 KHz
• Output- NPN Open Collector Transistor, VOH = 30 VDC max.; VOL = 1 V max @ 150 mA.
• Max. Sensing Distance- 1.5 mm (0.059")
• Cable Type- PUR Jacketed 3 wire 24 AWG (Brown - +VDC, Blue - Common, Black - NPN O.C. Output)
• Cable Length- 10 Feet

Used / Removed from New Equipment

 

Learn More

Sensor, proximity. 10-30VDC 200mA. PNP NO. Tubular, threaded. Connector: clear, 4 Pin male micro. ISSC T30-D4680. Learn More

Sensor, proximity. 10-30VDC 200mA. M30 Flush mount, cylindrical, threaded. Sensing distance: 10mm. 1 LED for output energized. Operating temperature: -25 to 70 deg C. With male 4 pin micro connector P/N 9512-6310. Double marked T30/D4180. More info: http://www.altechcorp.com/PDFS/Splits/sensor6.pdf Learn More

Sensor, proximity. 10-30VDC 200mA. M18 non flush mount, cylindrical, threaded. Sensing distance: 8mm. 1 LED for output energized. Operating temperature: -25 to 70 deg C. With male 4 pin micro connector P/N 9512-6310. Double marked T18-D4680. More info: http://www.altechcorp.com/PDFS/Splits/sensor6.pdf Learn More

Sensor, proximity. 10-30VDC 200ma. Cylindrical, threaded. Sensing distance: 5mm. 1 LED for output energized. Operating temperature: -25 to 70 deg C. With attached male 4 pin micro connector P/N 9512-6310. Double marked T18/D4180. Complete with installation sheet and hardware. More info: http://www.altechcorp.com/PDFS/Splits/sensor6.pdf Learn More

Sensor, proximity. 10-30VDC 200mA. M12 flush mount, cylindrical, threaded, PNP NO. 1 LED for output energized. Sensing distance: 2.0mm. Connector: Type 63, 4 pin straight. Double marked ISSC T12-D4180. Learn More