Sensors

Light wand phototransistor in a pen assembly. Bar code reader. (Universal = will work for anything it was meant for). Cord is approximately 15 feet long. Note: 23pcs have a DE9 male & 11 have a circular connectors. Learn More

Current sensing switch 30Amp 5%, max res 0.0004. Double marked RCA 3640834-13. Module: 3.855" long x 0.75" deep x 0.876" tall with heavy gauge tabs on each end. Overall with tabs 6" long. RFE/Removed from equipment. Learn More

Current sensing switch 20Amp 5%, max res 0.0004. Double marked RCA 3640834-10. Module: 3.855" long x 0.75" deep x 0.876" tall with heavy gauge tabs on each end. Overall with tabs 6" long. RFE/Removed from equipment. Learn More

Current sensing switch 34Amp 5%, max res 0.0004. Module: 3.855" long x 0.75" deep x 0.876" tall with heavy gauge tabs on each end. Overall with tabs 6" long. RFE/Removed from equipment. Learn More

Piezoelectric accelerometer. Triaxial. Typical measurements: X=3.96pC/g, Y=4.05pC/g, Z=3.61pC/g. Each in a wooden case. Used/Removed from equipment. Sold As Is. Learn More

Clairex - CLM5H10A Opto-Isolator,  17mA, 10V, Photo Mod Low Current Module,  New Photo Resistor Photo Cell/Lamp module 3K Ohm - "ON" Resistance, 10 meg. Ohm "Off" Resistance, 10V Dimensions - .415" Diameter by 1.125" Legnth, Cell Volts PAC - 100, Isolation Voltage PAC - 2500.

Obsolete Factory new Manuf spec's: www.datasheetarchive.com

Learn More

Photo-resistive cell. No other information available. Learn More

Cover for OTBVN6QD Opto-Touch Switch, plastic guard, housing only. Learn More

Photoelectric sensor. Fiber optic microswitch. LO/DO NPN 20mm range. Red: DC10-28V. White: output. Green: LO/DO. Black: OV. Learn More

Sensor, light. Receiver probe. On Belden 8451 22-2C foil shielded cable, solid. Length: 5 foot. More info: http://www.autodev.com/assets/downloads/sensors-controllers/ig01.01---8800-instructions_2008.pdf Learn More

Banner Engineering Corp - RSBFV - Visible Red 650nm fiber optic Sensor Head

Designed for use with GLASS fiber optics, Not plastic

Light Source: Infrared

Sensing Method: Diffused

Range to 10" [see excess gain charts]

Response to 1mS in HS mode only

RSBFV will Not operate with 2-wire power blocks

LIGHT/DARK Operate

Programming ring with four notches.

Dimensions: Height 48mm, Length 114mm

Alternate: Mouser 778-RSBFV

New

Learn More

Encoder. Marked: Resocoder. Mount: Panel, mount plate 2.654" square with 4 holes at 2.85" centers. Dimensions: body 2.5" D x 3.42" long, plus shaft, mount flange and connector. Shaft: 0.38" D x 0.846" long. Has one 10 Position male circular connector, part number MS3102E18-1P. Used/Removed from equipment. Overall length of unit is 5.75". Note: No other information available. Learn More

CURRENT SENSOR Learn More

Cutler-Hammer / Eaton -  E57MCL12T111 - Premium Proximity Sensor,

PNP, Open Collector.

E57 Inductive PNP sensor NO-NC

12mm, 303 Staunless Steel Enclosure

10-30VDC 500mA max, with Viewable 360 degree LED.

Sensing Range: 2MM

Accuracy: <1% Sensing Range

4 Wire, Polyvinyl Chloride (PVC) Cable

Package: Tubular.

Protection: Auto Reset

Temperature: 13F to 158 F

Dimensions: L 2.46" X H 0.47" X w 0.47"L

Cord Length 79.2"

CSA Certified, UL Listed

In Manufafcturer's Packaging with Instruction/Datasheet

UPC 78-2113-12540

Made in Germany

Learn More

WattStopper - HB350W-L3 - High Bay Passive Infrared Occupancy Motion Sensor for Wet Locations

The HB350W-L3 High Bay Passive Infrared (PIR) Occupancy Sensors for Wet Locations consist of a sensor and a lens
module. Designed for automatic lighting control in warehouses and other medium and high bay wet location applications.

The HB350W-L3 occupancy sensors are designed to mount to a light fixture and control one load in that fixture. They can be wired to control all ballasts in the fixture, or to control half of the ballasts, providing high/low lighting control. When motion is detected within the sensor’s coverage area, the relay in the sensor closes, and lighting loads are automatically turned on. When motion is no longer detected for the duration of the time delay setting, the relay opens and the lighting load is turned off. The sensor’s sensitivity and time delay settings are factory preset at “normal” and 15 minutes, respectively, which are suitable for high
bay applications. However, if the values need to be adjusted for specific applications, they can be easily changed using the DIP switches on the unit.

Weight: 6 Ounces

UPC: 754182924042

Additional Information: 

https://www.mc-mc.com/ASSETS/DOCUMENTS/ITEMS/EN/WattStopper_HB350W_L3_Installation_Instructions.pdf

https://assets.usesi.com/product-media/brochures/500654_brochure.pdf

New

 

Learn More

Encoders, rotary. Supply: 12VDC 150mA. Tolerance: 5%. 3600P/R 2 phase square wave + zero mark. Totem pole output, load resistance 470 Ohm min. Open collector output 40 VDC, 50mA or less. Timing can be selectable. More info: PG8 http://www.onosokki.co.jp/English/hp_e/whats_new/Catalog/PDF/RPseriesE.pdf

Learn More

Encoder, rotary. Case: slightly scratched. If used, it is in very good condition. Note: S/N 90162. Date code. 9-25-79. Learn More

Switch, thermostatic. 130 Deg F. Tolerance: 1%. Package: glass cylinder with 2 radial leads. Note: Thermostat. Learn More

Thermistor. Resistance: 33K Ohm. Tolerance: 5%. Type NTC. Series 2381. Package: radial leads. Dimensions: 3.3mm D x 24mm long x 3mm high. Learn More

VALIDYNE - DP45-16-2114 - Gould 369500-57035 - Transducer, Low Differential Pressure.

The Validyne DP45 Very Low Differential Pressure Transducer is designed for extremely low pressure measurement in the order of ±1 inch water column. This instrument is used extensively in connection with flow measurements where dynamic response at low flow rates is required. Dynamic line pressure effects are minimized due to the combination of low internal volume, symmetrical construction, and small volumetric displacement inherent in the DP45 design.

All surfaces exposed to the media are corrosion resistant steel. The design and construction of the DP45 permits the user to disassemble the instrument for cleaning, diaphragm replacement, or changing the transducer range. The transducer range is changed by substituting a different sensing diaphragm chosen from the Diaphragm Selection Chart on the reverse side of this sheet.

Used with a typical Validyne carrier demodulator, pressure inputs as low as 0.6 in. H2O will produce up to a ±10V output. The exceptionally low acceleration sensitivity of the DP45 ensure accuracy under all types of mounting conditions.

• Low range: ±0.6 to 90 in.H2O FS
• Low internal volume
• Symmetrical construction
• Small volumetric displacement
• High natural frequency

3.5CM.

Electrical Connector PT06A-10-6S

Mounting: Three Holes 6-32unc-28X.20 Deep ON 1.75- Diameter.

Dimensions: 57mm Diameter (2.24")

Additional Information https://www.validyne.com/product/dp45_low_pressure_variable_reluctance_sensor/

Alternate P/N: Gould 369500-57035.

Made in USA - Factory New With Specifications & Installation Drawing

Learn More

Rolling Ball Tilt Switch. Direction indicating Switch, TO-39-4 style case. Gold plated leads, and internal contact ball Highly Sensitive to detect basic motion/orientation. Environmentally safe, non-mercury electronic switch. Sealed type available for heavy humidity environment, free from bad connection or problems caused by contact oxidization. Poor man's accelerometer. The TO-39 package is a family of metallic can package used for hermetically sealing devices. The metal case can be gold coated. An internal gold-plated ball inside the sealed case touches one of 4 leads when tilted about 25-degrees or more. Since the leads are 90-deg apart you can sense which direction the device is leaning or tie the 4 together and any shaking or movement off level will cause contact closure. Has four leads on the bottom and one on top. Rolling Ball Tilt sensors allow you to detect orientation or inclination. They are small, inexpensive, low-power and easy-to-use. If used properly, they will not wear out (100,000 Cycle life). Their simplicity makes them popular for projects, toys, gadgets and appliances. Typical Applications - Alarms, Safety, Security, Directional Position, Vibration, Movement Detection, Portable Heaters, Games, Toys. Last picture shows a dissected TO-39 case to show internal gold plated ball and four Gold plated contact leads. Mounting: Through Hole (PCB) Operating Temperature: -20 C to 70 C Alternates/Similar Devices: RB-220-07A R, RB-231X2, AG1262-1, 1835-1156-ND, RBS040200 Made in USA Vintage - New Old Stock Significant discounts provided for bulk purchases. Learn More

Transducers. Ultrasonic speaker. Bandwidth: 0.4KHz. Power rating (undistorted) 10mW. Power rating (maximum) 100mW. Radiation angle: approximately: 60 Deg. With rubber boot/jacket. This transducer maybe used as a transmitter or receiver. Its frequency is approximately 40KHz which is well above the audible range. This device is ideally suited for construction of remote control switches, intrusion detector, etc.

Learn More

TURCK - Bi20-G47-AZ3X-B2131 Proximity sensor. Inductive.

Sensing distance 20mm.

Switches 20-250VAC 3-400mA.

Switches 10-300VDC 3-300mA.

Flush 47mm 2Wire.

Housing Material: Brass

Mount: Flush

Operating Temperature:  -25 °C to 70 °C

Operating Supply Voltage:250 V

Switching Frequency: 20 Hz

Termination: Connector

Dimensions: Length 76 mm

Compliance Ratings: IP67

RoHS Compliant

With attached connector.

Learn More

TURCK - Ni20NF-CP40-VN6X - TURCK - Ni20NF-CP40 - Sensor, Proximity.

Status: Discontinued

NI20NF Series

Inductive.

10-30VDC 200mA.

Sensing Distance: 10-20mm.

P=18ROT.

IP Rating: IP67

Used / Removed from Equipment

Learn More